BS 5502-25:1991:2002 Edition
$167.15
Buildings and structures for agriculture – Code of practice for design and installation of services and facilities
| Published By | Publication Date | Number of Pages |
| BSI | 2002 | 38 |
This part of BS 5502 gives recommendations on the design and installation of electrical, gas and water services, and drainage for use in buildings and structures used for agriculture. It also gives guidance on the storage of liquid fuels and the installation of heater chimneys.
NOTE The titles of the publications referred to in this standard are listed on page 31.
Recommendations for the design and installation of services, storage of liquid fuels and the installation of chimneys for agricultural buildings and structures.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | Committees responsible for this British�Standard |
| 3 | Contents |
| 5 | 1 Scope 2 Definitions 2.1 oil storage tank 2.2 oil service tank 2.3 oil tank chamber 2.4 transportable motor 3 Drainage 3.1 General 3.2 Surface water 3.3 Human waste 3.4 Agricultural and horticultural trade wastes |
| 8 | 4 Water services 4.1 General 4.2 Water supply to farm and horticultural holdings 4.3 Water supply for fire fighting 4.4 General recommendations 4.5 Service pipework 4.6 Taps and valves |
| 9 | Table 1 – Recommendations for service pipework |
| 10 | Table 2 – Types of taps and valves 4.7 Storage cisterns |
| 11 | Table 3 – Recommendations for storage cisterns and tanks |
| 12 | 5 Storage of liquid fuel 5.1 Installation and equipment 5.2 Oil tank chamber 5.3 Ventilation of oil tank chamber 5.4 Electrical and lighting arrangements in tank chambers 5.5 Storage tanks |
| 13 | Figure 1 – Diagram of a typical oil storage tank |
| 14 | 5.6 Service tanks 5.7 Bund |
| 15 | 5.8 Ancillary equipment |
| 16 | 5.9 Warning signs 6 Gas including liquefied petroleum gas (LPG) and compressed air services 6.1 General 6.2 Special requirements for pipe installation |
| 17 | 6.3 Installations of livestock buildings 6.4 LPG installations 6.5 Compressed air installations 7 Electrical services 7.1 General 7.2 Installations 7.3 Exchange of information 7.4 Wiring diagrams |
| 18 | 7.5 Design considerations and operating conditions 7.6 Incoming electricity supply 7.7 Layout of installation 7.8 Heating and lighting |
| 19 | 7.9 Precautions against special conditions 7.10 Installation in oil tank chambers 7.11 Safety controls: electrical and mechanical installations 7.12 Distribution systems |
| 24 | Table 4 – Maximum spans and minimum heights of overhead cables |
| 27 | 8 Chimneys, flues and heating appliances 8.1 Statutory requirements 8.2 Siting 8.3 Design |
| 28 | 8.4 Insulation and lining of chimneys |
| 29 | 8.5 Construction of chimneys and flues 8.6 Conditioning and drying of crops 8.7 Heating in livestock buildings |
| 31 | 9 Safety and security 10 Workmanship |
