🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN 13743:2017

BS EN 13743:2017

$102.76

Safety requirements for coated abrasive products

Published By Publication Date Number of Pages
BSI 2017 22
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This European Standard is applicable to the following coated abrasive products and a combination of coated and non-woven abrasive products: flap wheels, flap discs, vulcanised fibre discs and spindle mounted flap wheels. It also applies to back-up pads for vulcanised fibre discs. These products are manufactured using the following abrasive grains: aluminium oxide, silicon carbide, diamond, or CBN. This European Standard specifies requirements and/or measures for removal or reduction of hazards resulting from the design and application of the coated abrasive products and clamping devices. This European Standard also contains procedures and tests for verification of compliance with the requirements as well as safety information for use, which is to be made available to the user by the manufacturer. The hazards taken into consideration are listed in Clause 4 of this standard. This European Standard does not apply to abrasive products entirely of non-woven web.

PDF Catalog

PDF Pages PDF Title
4 Contents Page
5 European foreword
6 Introduction
7 1 Scope
2 Normative references
3 Terms and definitions
3.1 General
3.2 Grinding machines
8 3.3 Type of application
3.3.1 General
Table 1 — Type of application
9 3.4 Symbols
Table 2 — Symbols
4 List of significant hazards
10 Table 3 — List of significant hazards
5 Safety requirements
5.1 General requirements
5.1.1 General
5.1.2 Sequence of maximum operating speeds
11 5.2 Safety factors
5.2.1 Safety factors for flap wheels, flap discs and vulcanised fibre discs
Table 4 — Safety factors
5.2.2 Safety factors for spindle mounted flap wheels
5.2.3 Safety factor for back-up pads for vulcanised fibre discs
5.3 Dimensional limitations and maximum operating speeds
12 Table 5 — Dimensional limitations and maximum operating speeds
13 5.4 Marking
6 Verification of the safety requirements
6.1 Verification of the general requirements
6.2 Verification of the safety factor
14 6.3 Verification of the dimensional requirements
6.4 Verification of the marking
7 Information for use
15 Annex A (normative) Marking
A.1 Content of marking
A.1.1 Marking requirements
Table A.1 — Marking of coated abrasive products and back-up pads
17 Table A.2 — Restrictions of use
A.1.2 Additional inscriptions
A.2 Execution of marking
18 Annex B (normative) Colour codes
Table B.1 — Colour codes and design of colour codes
19 Annex C (informative) Speed conversion table
Table C.1 — Speed conversion
20 Bibliography

Related products

BS EN 13743:2017
$102.76