šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
BS EN 16661:2015

BS EN 16661:2015

$142.49

Road vehicles and Tyre Pressure Gauges (TPG). Interoperability between Tyre Information Systems (TIS) and TPG. Interfaces and Requirements

Published By Publication Date Number of Pages
BSI 2015 30
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

This European Standard applies to the tyre pressure gauges (TPG) which operate using pressure equipment (devices used in fixed or mobile installations) to inflate the tyres of road using vehicles (M1 and M2 categories) and which may be capable of interacting with vehicles equipped with tyre pressure monitoring systems (TPMS) whereby the TPG may be steered by the TPMS/vehicle.

To set the correct tyre inflation, this European Standard defines requirements and processes for the interoperability of TPG with TPMS/vehicle, through standardized interfaces and data exchange formats allowing advanced information, management and control systems between TPG and TPMS/vehicle. The architecture is open and scalable to support the different levels of interoperability (from full interoperability to fully manual).

This European Standard does not define communication protocols (works specifically made under M/453 European mandate).

This European Standard may be applied to all TPG categories referenced in EN 12645 .

The driver/operator is considered as being responsible for the validation of the parameters and tyre pressure.

This European Standard will be applicable upon development of Infrastructure solution (V2I-I2V communication solutions)

PDF Catalog

PDF Pages PDF Title
4 Contents Page
5 Foreword
6 Introduction
7 1 Scope
2 Normative references
3 Conformance
8 4 Terms and definitions
10 5 Symbols and abbreviations
11 6 Requirements
6.1 Levels of interoperability
6.2 Required parameters provided by TIS, depending on level of interoperability
6.2.1 General
12 6.2.2 Basic parameters
Table 1 ā€” Basic parameter
6.2.3 Placard table information for vehicle platform
Table 2 ā€” Placard table information
15 6.2.4 Vehicle-specific data for increasing the level of interoperability
16 Table 3 ā€” Vehicle-specific data for increasing the level of interoperability
19 6.2.5 Feedback information from the TPG to the TIS
Table 4 ā€” Feedback parameter
7 Process requirements
20 Figure 1 ā€” Filling process flow
8 Test conditions
21 9 Test methods
Table 5 ā€” TIS profiles
24 Annex A (normative) Parameter conversions
Table A.1 ā€” ASCII 4 Bit
25 Table A.2 ā€” ASCII 5 Bit
26 Annex B (normative) Tyre dimension and type
Table B.1 ā€” Tyre dimension and type
27 Bibliography

Related products

BS EN 16661:2015
$142.49