Shopping Cart

No products in the cart.

BS EN 17263:2019

$86.31

Copper and copper alloys. Eddy current testing on the outer surface of rods, bars, hollow rods and wires for the detection of defects by encircling test coil

Published By Publication Date Number of Pages
BSI 2019 14
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document specifies a procedure for fully automatic eddy current testing with no operator involvement with an encircling test coil for detecting defects on the surface of copper and copper alloy rods, bars, hollow rods and wires with a minimum diameter or width across flats defined in the relevant product standards. This test method can be continuous or discontinuous depending on the product. The product size range and test acceptance level are defined in the relevant product standards.

PDF Catalog

PDF Pages PDF Title
2 National foreword
5 European foreword
6 Introduction
7 1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
8 5 Personnel qualification
6 Eddy Current Test equipment
6.1 Test layout
6.1.1 Nominal frequency
9 6.1.2 Test coil
6.2 Reference standard
10 7 Calibration and Verification
11 8 Acceptance criteria
8.1 Detection of single local discontinuity by encircling coil systems
8.2 Detection of several local surface effects by encircling coil systems by using low signal amplitudes as detection threshold
12 9 Other methods
10 Documentation
13 Bibliography
BS EN 17263:2019
$86.31