BS EN 60317-0-9:2015
$142.49
Specifications for particular types of winding wires – General requirements. Enamelled rectangular aluminium wire
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 32 |
This part of IEC 60317 specifies the general requirements of enamelled rectangular aluminium winding wires.
The range of nominal conductor dimensions is given in the relevant specification sheet.
When reference is made to a winding wire according to a standard of the IEC 60317 series mentioned under Clause 2, the following information is given in the description:
-
– reference to IEC specification;
-
– nominal conductor dimensions in millimetres (width × thickness);
-
– grade.
EXAMPLE IEC 60317-16 – 4,00 x 1,00 Grade 1
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 8 | FOREWORD |
| 10 | INTRODUCTION |
| 11 | 1 Scope 2 Normative references 3 Terms, definitions, general notes and appearance 3.1 Terms and definitions 3.2 General notes 3.2.1 Methods of test |
| 12 | 3.2.2 Winding wire 3.3 Appearance 4 Dimensions 4.1 Conductor dimensions |
| 13 | 4.2 Tolerance on conductor dimensions 4.3 Rounding of corners Tables Table 1– Conductor tolerances |
| 14 | Table 2 – Nominal cross-sectional areas of preferred sizes |
| 15 | 4.4 Increase in dimensions due to the insulation 4.5 Overall dimensions 4.5.1 Nominal overall dimensions 4.5.2 Minimum overall dimensions 4.5.3 Maximum overall dimensions Table 3 – Corner radii Table 4 – Increases in dimensions |
| 16 | 5 Electrical resistance 6 Elongation 7 Springiness 8 Flexibility and adherence 8.1 Mandrel winding test 8.2 Adherence test 9 Heat shock 10 Cut-through Table 5 – Mandrel winding |
| 17 | 11 Resistance to abrasion 12 Resistance to solvents 13 Breakdown voltage 14 Continuity of insulation 15 Temperature index 16 Resistance to refrigerants Table 6 – Breakdown voltage |
| 18 | 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass 23 Pin hole test 30 Packaging |
| 19 | Annex A (informative) Nominal cross-sectional areas for preferred and intermediate sizes Table A.1 – Nominal cross-sectional areas (1 of 9) |
| 28 | Annex B (informative) Special tolerances Table B.1 – Overall dimensional tolerances for grade 2 |
| 29 | Bibliography |
Related products
-
BS EN 60317-0-9:2015
Specifications for particular types of winding wires – General requirements. Enamelled rectangular aluminium wire Published…
-
BS EN IEC 60317-74:2018
Specifications for particular types of winding wires – Polyesterimide enamelled rectangular aluminium wire, class 180…
-
BS EN IEC 60317-74:2018
Specifications for particular types of winding wires – Polyesterimide enamelled rectangular aluminium wire, class 180…
