BS EN 60317-17:2010
$86.31
Specifications for particular types of winding wires – Polyvinyl acetal enamelled rectangular copper wire, class 105
| Published By | Publication Date | Number of Pages |
| BSI | 2010 | 14 |
This part of IEC 60317 specifies the requirements of enamelled rectangular copper winding wire of class 105 with a sole coating based on polyvinyl acetal resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements.
NOTE A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics.
Class 105 is a thermal class that requires a minimum temperature index of 105 and a heat shock temperature of at least 155 °C.
The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved.
The range of nominal conductor dimensions covered by this standard is
Wires of grade 1 and grade 2 are included in this specification and apply to the complete range of conductors.
The specified combinations of width and thickness as well as the specified ratio width/thickness are given in IEC 60317-0-2.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 7 | INTRODUCTION |
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Terms, definitions and general notes on methods of test and appearance 3.1 Terms and definitions 3.2 General notes on methods of test 3.3 Appearance 4 Dimensions 5 Electrical resistance 6 Elongation 7 Springiness 8 Flexibility and adherence 8.1 Mandrel winding test 8.2 Stretching test Table 1 – Mandrel winding |
| 10 | 9 Heat shock 10 Cut-through 11 Resistance to abrasion 12 Resistance to solvents 13 Breakdown voltage 14 Continuity of insulation 15 Temperature index 16 Resistance to refrigerants 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor |
| 11 | 20 Resistance to transformer oil 21 Loss of mass 23 Pin hole test 30 Packaging |
