BS EN 60317-57:2010
$86.31
Specifications for particular types of winding wires – Polyamide-imide enamelled round copper wire, class 220
| Published By | Publication Date | Number of Pages |
| BSI | 2010 | 14 |
This part of IEC 60317 specifies the requirements of an enamelled round copper winding wire of class 220 with a sole coating based on polyamide-imide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements.
Class 220 is a thermal class that requires a minimum temperature index of 220 and a heat shock temperature of at least 240 ºC.
The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved.
The range of nominal conductor diameters covered by this standard is as follows:
-
Grade 1: 0,071 mm up to and including 1,600 mm;
-
Grade 2: 0,071 mm up to and including 1,600 mm.
The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 7 | INTRODUCTION |
| 8 | 1 Scope 2 Normative references 3 Definitions, general notes on methods of test and appearance 3.1 Definitions and general notes on methods of test 3.2 Appearance 4 Dimensions |
| 9 | 5 Electrical resistance 6 Elongation 7 Springiness 8 Flexibility and adherence 9 Heat shock 10 Cut-through 11 Resistance to abrasion |
| 10 | 12 Resistance to solvents 13 Breakdown voltage 14 Continuity of insulation 15 Temperature index 16 Resistance to refrigerants 17 Solderability Table 1 – Resistance to abrasion |
| 11 | 18 Heat bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass 22 High temperature failure 23 Pin hole test 30 Packaging |
Related products
-
BS EN 60317-57:2010
Specifications for particular types of winding wires – Polyamide-imide enamelled round copper wire, class 220…
