BS EN 61300-1:2011
$102.76
Fibre optic interconnecting devices and passive components. Basic test and measurement procedures – General and guidance
| Published By | Publication Date | Number of Pages |
| BSI | 2011 | 22 |
IEC 61300-1:2011 contains a series of environmental test and measurement procedures and, in some cases, preferred severities designed to assess the ability of fibre optic interconnecting devices and passive components to perform under expected service conditions. Although the severities are primarily intended for land-based communications, the procedures may be used for other applications. The object of this standard is to provide uniform and reproducible environmental test procedures and measurement procedures, for those preparing specifications for fibre optic interconnecting devices and passive components. The changes with respect to the previous edition are to reconsider the terms and definitions and multimode launch conditions.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 7 | INTRODUCTION |
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Terms and definitions |
| 10 | 4 Standard atmospheric conditions 5 Significance of the numerical value of a quantity 5.1 General 5.2 Quantity expressed as nominal value with tolerance Tables Table 1 – Standard Atmospheric Conditions |
| 11 | 5.3 Quantity expressed as a range of values |
| 12 | 6 Graphical symbols and terminology 7 Safety 8 Calibration 8.1 General 8.2 Round robin calibration procedure 9 Launch conditions 9.1 General |
| 13 | 9.2 Multimode launch conditions 9.3 Single-mode launch conditions Table 2 – Expected uncertainty for measured attenuation of single connectors |
| 14 | Annex A (informative) Round robin calibration procedure for dimensional measurements on ferrules and sleeves |
| 15 | Figures Figure A.1 – Flow chart of round robin calibration procedure |
| 16 | Figure A.2 – Examples for the determination of the measurement points and the marking of the round robin standards |
| 17 | Annex B (normative) Multimode launch condition requirements for measuring attenuation |
| 18 | Figure B.1 – Encircled Flux template example |
| 19 | Table B.1 – EF requirements for 50 um core fibre at 850 nm Table B.2 – EF requirements for 50 um core fibre at 1300 nm Table B.3 – EF requirements for 62,5 um fibre at 850 nm Table B.4 – EF requirements for 62,5 um fibre at 1300 nm |
| 20 | Bibliography |
