BS EN IEC 60317-25:2020
$102.76
Specifications for particular types of winding wires – Polyester or polyesterimide overcoated with polyamide-imide enamelled round aluminium wire, class 200
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 16 |
IEC 60317-25:2020 is available as IEC 60317-25:2020 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.IEC 60317-25:2020 specifies the requirements of enamelled round aluminium winding wires of class 200 with a dual coating. The underlying coating is based on polyester or polyesterimide resin, which can be modified provided it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is based on polyamide-imide resin. NOTE A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics. The range of nominal conductor diameters covered by this document is: – Grade 1: 0,250 mm up to and including 3,150 mm; – Grade 2: 0,250 mm up to and including 5,000 mm. The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-3:2008 and IEC 60317-0-3:2008/AMD1:2013. This fourth edition cancels and replaces the third edition published in 2010. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: – new 3.2.2 containing general notes on winding wire, formerly a part of the Scope; – revision to Clause 11 to take into account intermediate nominal conductor diameters; – revision to Clause 7 to indicate that the springiness test is inappropriate. – revision to Clause 16 to specify only the percentage of extractable matter and the minimum retained dielectric breakdown voltage.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
| 7 | English CONTENTS |
| 8 | FOREWORD |
| 10 | INTRODUCTION |
| 11 | 1 Scope 2 Normative references 3 Terms, definitions, general notes and appearance 3.1 Terms and definitions |
| 12 | 3.2 General notes 3.2.1 Methods of test 3.2.2 Winding wire 3.3 Appearance 4 Dimensions 5 Electrical resistance 6 Elongation 7 Springiness 8 Flexibility and adherence 9 Heat shock 10 Cut-through |
| 13 | 11 Resistance to abrasion (nominal conductor diameters up to and including 2,500 mm) 12 Resistance to solvents 13 Breakdown voltage 14 Continuity of insulation 15 Temperature index Table 1 – Resistance to abrasion |
| 14 | 16 Resistance to refrigerants 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass 23 Pin hole test 30 Packaging |
| 15 | Bibliography |
