🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN IEC 62677-1:2018

BS EN IEC 62677-1:2018

$102.76

Heat shrinkable low and medium voltage moulded shapes – General requirements (IEC 62677-1:2017)

Published By Publication Date Number of Pages
BSI 2018 16
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document is applicable to heat shrinkable low and medium voltage moulded shapes in a range of configurations and materials suitable for insulation, environmental sealing, mechanical protection, electrical conductance, anti-tracking and strain relief for power cable terminations, joints and stop ends. It specifies the test methods and material requirements. The most commonly available shapes are as shown in the Annex A.

Materials which conform to this document meet established levels of performance. However, the selection of a material by a user for a specific application will be based on the actual requirements necessary for adequate performance in that application and will not be based on this document alone.

These moulded shapes are designed to be used in low and medium voltage cable accessories and as such electrical performance will be proven as part of the assembly. Examples of this are described in EN 50393, HD 629.1 and IEC 60502-4.

PDF Catalog

PDF Pages PDF Title
2 undefined
5 Annex ZA(normative)Normative references to international publicationswith their corresponding European publications
7 English
CONTENTS
8 FOREWORD
10 INTRODUCTION
11 1 Scope
2 Normative references
3 Terms and definitions
12 4 Moulded shape material specimens
5 Classification
6 Ordering
7 Dimensions
8 Colour
9 Finish
10 Packaging
13 11 Labelling
12 Qualification approval requirements
13 Consignment tests
14 Annex A (informative) Heat shrinkable moulded parts (typical configuration)
Figure A.1 – Typical configuration of heat shrinkable moulded parts
15 Bibliography

Related products

BS EN IEC 62677-1:2018
$102.76