🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN IEC 63182-2:2020

BS EN IEC 63182-2:2020

$102.76

Magnetic powder cores. Guidelines on dimensions and the limits of surface irregularities – Ring-cores

Published By Publication Date Number of Pages
BSI 2020 18
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

IEC 63182-2:2020 specifies the dimensions that are of importance for mechanical interchangeability for a preferred range of ring-cores (also called toroids) made of magnetic powder, the effective parameter values to be used in calculations involving them, and gives guidelines on allowable limits of surface irregularities applicable to coated ring-cores. The selection of core sizes for this document is based on the philosophy of including those sizes which are industrial standards, meaning that they are in broad-based use within the industry. This document is considered as a sectional specification useful in the negotiations between magnetic powder core manufacturers and users about surface irregularities.

PDF Catalog

PDF Pages PDF Title
2 undefined
5 Annex ZA(normative)Normative references to international publicationswith their corresponding European publications
7 English
CONTENTS
8 FOREWORD
10 1 Scope
2 Normative references
3 Terms and definitions
4 Primary standards
4.1 General
11 4.2 Dimension descriptions
4.3 Dimensions of ring-cores
4.4 Chamfered edges
Figures
Figure 1 – Dimensions of ring-cores
Figure 2 – Chamfered edges of ring-cores
Table 1 – Dimensions descriptions
12 4.5 Effective parameter values
Table 2 – Dimensions and geometrically calculated values for ring-cores
13 5 Limits of surface irregularities
5.1 Cracks
5.2 Peeling
Figure 3 – Cracks
14 5.3 Pinholes
5.4 Sharp chamfered edge
Figure 4 – Peeling
Figure 5 – Pinholes
Figure 6 – Sharp chamfered edge
15 5.5 Bubbles
5.6 Unevenness
Figure 7 – Bubbles
Figure 8 – Unevenness
16 Annex A (normative)Calculation method for the effective parameters of ring-cores

Related products

BS EN IEC 63182-2:2020
$102.76