BS EN ISO 13934-2:2014
$102.76
Textiles. Tensile properties of fabrics – Determination of maximum force using the grab method
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 20 |
This part of ISO 13934 specifies a procedure for the determination of the maximum force of textile fabrics known as the grab test.
NOTE ISO 13934-1 describes the method known as the strip test.
The method is mainly applicable to woven textile fabrics including fabrics which exhibit stretch characteristics imparted by the presence of an elastomeric fibre and mechanical or chemical treatment. It can be applicable to fabrics produced by other techniques. It is not normally applicable to geotextiles, nonwovens, coated fabrics, textile-glass woven fabrics, and fabrics made from carbon fibres or polyolefin tape yarns.
The method specifies the determination of the maximum force of test specimens in equilibrium with the standard atmosphere for testing and of test specimens in the wet state.
The method is restricted to the use of constant-rate-of-extension (CRE) testing machines.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | Section sec_3.3 Section sec_3.4 Section sec_4 Section sec_5 Section sec_6 Section sec_6.1 Section sec_6.1.1 Section sec_6.1.2 Section sec_6.1.3 Section sec_6.1.4 4 Principle 5 Sampling 6 Apparatus |
| 11 | Section sec_6.1.5 Section sec_6.1.6 Section sec_6.2 Section sec_6.3 Section sec_6.4 Section sec_6.5 Section sec_7 Section sec_8 Section sec_8.1 7 Atmosphere for conditioning and testing 8 Preparation of test specimens 8.1 General |
| 12 | Section sec_8.2 Section sec_8.3 Section sec_8.4 Section sec_8.4.1 Section sec_8.4.2 Section sec_9 Section sec_9.1 Section sec_9.2 Section sec_9.3 Section sec_9.4 8.2 Dimensions 8.3 Preparation of test specimens 8.4 Wet test specimens 9 Procedure 9.1 Gauge length 9.2 Rate of extension 9.3 Mounting of test specimens 9.4 Operation |
| 13 | Section sec_9.5 Section sec_10 Section sec_11 9.5 Tests on wet test specimens 10 Calculation and expression of results 11 Test report |
| 14 | Annex sec_A Annex sec_A.1 Table tab_A.1 Annex sec_A.2 Annex A (informative) Suggested procedure for sampling |
| 15 | Annex sec_B Table tab_a Figure fig_B.1 Annex B (informative) Locations of test specimens cut from a laboratory sample |
| 16 | Annex sec_C Table tab_b Figure fig_C.1 Annex C (informative) Arrangements of jaws for the grab test |
| 17 | Reference ref_1 Reference ref_2 Reference ref_3 Reference ref_4 Reference ref_5 Reference ref_6 Reference ref_7 Bibliography |
