BS EN ISO 14270:2016
$142.49
Resistance welding. Destructive testing of welds. Specimen dimensions and procedure for mechanized peel testing resistance spot, seam and embossed projection welds
| Published By | Publication Date | Number of Pages |
| BSI | 2016 | 28 |
This International Standard specifies specimen dimensions and a testing procedure for mechanized peel testing of single spot, seam and embossed projection welds, in overlapping sheets, in any metallic material of thickness 0,5 mm to 3 mm, where the welds have a maximum diameter of 7√ t (where t is the sheet thickness in mm).
For welds of diameter between 5√ t and 7√ t, the peel strength values obtained may be lower than expected when using the recommended test specimen dimensions because the test specimen width is designed for welds of diameter of 5√ t or less.
The object of mechanized peel testing is to determine the peel strength that the test specimen can sustain.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | European foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | 4 Test pieces and specimens |
| 13 | 5 Preparation of mechanized peel test specimens 5.1 General 5.2 Bending procedure of weld test specimens after welding 5.3 Bending procedure of test specimens before welding — Alternative procedure |
| 16 | 5.4 Dimensions and accuracy |
| 17 | 6 Peel testing procedure and test equipment |
| 18 | 7 Re-test 8 Test report |
| 20 | Annex A (normative) Measurement of seam weld size |
| 21 | Annex B (informative) Influence of spot weld position on test results |
| 22 | Annex C (informative) Examples of bending tools |
| 24 | Annex D (informative) Determination of the bending centre position with press brake systems |
| 25 | Bibliography |
Related products
-
BS EN ISO 14270:2016 – TC:2020 Edition
Tracked Changes. Resistance welding. Destructive testing of welds. Specimen dimensions and procedure for mechanized peel…
