BS EN ISO 1452-3:2009:2010 Edition
$189.07
Plastics piping systems for water supply and for buried and above-ground drainage and sewerage under pressure. Unplasticized poly(vinyl chloride) (PVC U) – Fittings
| Published By | Publication Date | Number of Pages |
| BSI | 2010 | 46 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 9 | Scope |
| 10 | Normative references |
| 11 | Terms, definitions, symbols and abbreviated terms Terms and definitions Symbols Material Fitting material Density |
| 12 | MRS-value General characteristics Appearance Colour Opacity of fittings intended for the above-ground conveyance Geometrical characteristics Measurement of dimensions Nominal diameters Fittings for solvent cementing Socket and spigot dimensions |
| 13 | Diameters, laying lengths, bend radii and angles |
| 20 | Adapter fittings Designation of adapter fittings Reinforcement of adapter fittings |
| 21 | Dimensions of adapter fittings |
| 22 | Tapping saddles |
| 25 | Flange adapters and flanges Adapters for backing flange |
| 26 | Flanges |
| 28 | Elastomeric ring seal fittings Socket and spigot dimensions Minimum depth of engagement for socketed fittings and length |
| 29 | Diameters, laying lengths, design lengths, bend radii and an |
| 37 | Wall thicknesses End-load-bearing double-sockets with elastomeric seals Classification and operating conditions Classification Selection of nominal pressure and pipe series S for water up |
| 38 | Determination of the allowable operating pressure for water Mechanical characteristics Resistance to internal pressure of fittings or parts of fitt |
| 39 | Crushing test Physical characteristics |
| 40 | Sealing rings Adhesives Performance requirements Marking General Minimum required marking |
| 41 | Additional marking |
