Shopping Cart

No products in the cart.

BS EN ISO 19679:2020

$102.76

Plastics. Determination of aerobic biodegradation of non-floating plastic materials in a seawater/sediment interface. Method by analysis of evolved carbon dioxide

Published By Publication Date Number of Pages
BSI 2020 20
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document specifies a test method to determine the degree and rate of aerobic biodegradation of plastic materials when settled on marine sandy sediment at the interface between seawater and the seafloor, by measuring the evolved carbon dioxide (CO2). This test method can also be applied to other solid materials.

This test method is a simulation under laboratory conditions of the habitat found in different seawater/sediment-areas in the sea, e.g. in a benthic zone where sunlight reaches the ocean floor (photic zone) that, in marine science, is called sublittoral zone

The determination of biodegradation of plastic materials and other solid materials buried in marine sediment is outside the scope of this document.

NOTE

Measurement of aerobic biodegradation can also be obtained by monitoring the oxygen consumption, as described in ISO 18830 .

The conditions described in this document do not always correspond to the optimum conditions for the maximum degree of biodegradation to occur.

PDF Catalog

PDF Pages PDF Title
2 National foreword
4 European foreword
6 Foreword
7 Introduction
9 1 Scope
2 Normative references
3 Terms and definitions
10 4 Principle
5 Test environment
6 Reagents
11 7 Apparatus
8 Procedure
8.1 Test material
12 8.2 Reference material
8.3 Preparation of the sediment
8.4 Test setup
8.5 Pre-conditioning phase
13 8.6 Start of the test
8.7 Carbon dioxide measurement
14 8.8 End of the test
9 Calculation and expression of results
9.1 Calculation
9.1.1 Amount of CO2 produced
16 9.1.2 Percentage of biodegradation
9.2 Visual inspection
9.3 Expression and interpretation of results
17 10 Validity of results
11 Test report
18 Annex A (informative) Example of respirometric system based on CO2 measurement
19 Bibliography
BS EN ISO 19679:2020
$102.76