BS EN ISO 22007-6:2015
$102.76
Plastics. Determination of thermal conductivity and thermal diffusivity – Comparative method for low thermal conductivities using a temperature-modulation technique
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 22 |
This part of ISO 22007 specifies a modulated temperature method realizing the measurement of thermal conductivity. An input of temperature deviation is less than 1 K, and a double lock-in method is applied to amplify the small temperature modulation.
ISO 22007-3 specifies one of the modulated temperature methods where the phase shift is measured in the thermally thick condition, kd >> 1 [k = (ω/2α)1/2, ω: angular frequency of temperature wave, α: thermal diffusivity, and d: thickness of the specimen]. In this condition, the backing material does not affect on the phase shift results on the sensor, on which temperature wave decays exponentially.
On the other hand, if kd << 1, the decay of temperature modulation is influenced by the backing materials. Based on this principle, this part of ISO 22007 specifies the method to determine the thermal conductivity of the sample (as a backing material), comparing the decay of temperature wave detected on both surfaces of the probe material.
Thermal conductivity is determined from the correlation between the thermal impedance and the decay ratio of amplitude using two reference materials measured at the same frequency and temperature.
The covering thermal conductivity range is adjusted with the reference materials and the probe materials. Basically, thermal conductivity is determined in the range from 0,026 W/mK to 0,6 W/mK.
In the case applying the method to inhomogeneous materials, cares must be taken to choose the appropriate measurement conditions in accordance with the thermal penetration depth.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 1 Scope 2 Normative references |
| 8 | Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_3.3 Section sec_3.4 3 Terms and definitions |
| 9 | Section sec_4 Table tab_d Figure fig_1 4 Principle |
| 10 | Section sec_5 Section sec_5.1 Section sec_5.2 Section sec_5.2.1 Section sec_5.2.2 Section sec_5.2.3 Section sec_5.3 Table tab_e Figure fig_2 5 Apparatus |
| 11 | Table tab_f Figure fig_3 Section sec_5.4 Section sec_5.5 Section sec_6 Section sec_6.1 Section sec_6.2 6 Test specimens 6.1 Measuring temperature 6.2 Geometry of the probe material |
| 12 | Section sec_6.3 Section sec_6.4 Section sec_7 Section sec_7.1 Section sec_7.2 Section sec_7.3 Section sec_7.4 Section sec_7.5 Section sec_7.6 Section sec_7.7 Section sec_8 Section sec_8.1 6.3 Specimen area size 6.4 Specimen thickness 7 Procedure 8 Expression of results 8.1 Graphical presentation |
| 13 | Table tab_1 Figure fig_4 Section sec_8.2 Section sec_9 8.2 Verification 9 Test report |
| 15 | Annex sec_A Table tab_A.1 Table tab_A.2 Annex A (informative) Results of thermal conductivity of cellular plastics |
| 16 | Table tab_g Figure fig_A.1 |
| 17 | Annex sec_B Table tab_h Figure fig_B.1 Table tab_B.1 Annex B (informative) Infinite thickness |
| 18 | Reference ref_1 Reference ref_2 Bibliography |
