BS EN ISO 8029:2014
$142.49
Plastics hose. General-purpose collapsible water hose, textile-reinforced. Specification
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 28 |
This International Standard specifies the requirements for four types of textile-reinforced thermoplastics collapsible water hoses for general applications for use in the temperature range of −10 °C to 55 °C. Such hoses are classified into four types, as follows:
-
low pressure, designed for a maximum working pressure of up to 0,4 MPa (4,0 bar) at 23 °C and up to 0,2 MPa (2,0 bar) at 55 °C;
-
medium pressure, for a maximum working pressure of up to 0,7 MPa (7,0 bar) at 23 °C and up to 0,36 MPa (3,6 bar) at 55 °C;
-
high pressure, for a maximum working pressure of up to 1,0 MPa (10,0 bar) at 23 °C and up to 0,51 MPa (5,1 bar) at 55 °C;
-
extra-high pressure, for a maximum working pressure of up to 1,55 MPa (15,5 bar) at 23 °C and up to 0,79 MPa (7,9 bar) at 55 °C.
This International Standard does not apply to products used for fire-fighting or the conveyance of drinking water.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 1 Scope 2 Normative references |
| 10 | Section sec_3 Section sec_4 Section sec_5 Section sec_6 Section sec_7 Section sec_7.1 3 Terms and definitions 4 Classification 5 Couplings and end fittings 6 Materials and construction 7 Dimensions and tolerances 7.1 Inside diameter and tolerance |
| 11 | Table tab_1 Section sec_7.2 7.2 Tolerance on length |
| 12 | Section sec_8 Section sec_8.1 Table tab_2 Section sec_8.2 Section sec_8.2.1 8 Physical properties 8.1 Plastic compounds 8.2 Performance requirements for finished hose |
| 13 | Table tab_3 |
| 14 | Table tab_4 Section sec_8.2.2 |
| 15 | Table tab_5 |
| 16 | Table tab_6 Section sec_8.2.3 |
| 17 | Section sec_8.2.4 Section sec_8.2.5 Section sec_8.2.6 Section sec_9 Section sec_10 Section sec_11 9 Frequency of testing 10 Test certificate/report 11 Marking |
| 18 | Section sec_12 12 Recommendations for packaging and storage |
| 19 | Annex sec_A Annex sec_A.1 Annex sec_A.2 Annex sec_A.3 Annex A (normative) Abrasion test |
| 20 | Table tab_a Figure fig_A.1 |
| 21 | Annex sec_B Table tab_B.1 Annex B (normative) Type and routine testing |
| 22 | Annex sec_C Table tab_C.1 Annex C (informative) Production tests |
| 23 | Annex sec_D Annex D (informative) Couplings and end fittings |
| 24 | Reference ref_1 Reference ref_2 Reference ref_3 Bibliography |
