BS EN ISO 8503-2:2012
$102.76
Preparation of steel substrates before application of paints and related products. Surface roughness characteristics of blast-cleaned steel substrates – Method for the grading of surface profile of abrasive blast-cleaned steel. Comparator procedure
| Published By | Publication Date | Number of Pages |
| BSI | 2012 | 16 |
This part of ISO 8503 describes a visual and tactile method for assessing the grade of the profile which is produced by one of the abrasive blast-cleaning procedures described in ISO 8504-2.
The method uses ISO surface profile comparators for assessing, on site, the roughness of surfaces before the application of paint or other protective treatments.
NOTE Where appropriate, ISO surface profile comparators can be used for assessing the roughness profile of other abrasive blast-cleaned substrates and, in addition, their use is not restricted solely to surfaces that are to be painted.
The method is applicable to steel surfaces which have been blast-cleaned by use of either shot abrasives or grit abrasives, but is only applicable to grades Sa 2½ and Sa 3 of ISO 8501-1 where the entire surface under test shows an overall blast-cleaned appearance.
lt is applicable to surfaces which have been cleaned with either metallic or non-metallic abrasives.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | 4 Principle 5 Apparatus 6 Maintenance and re-calibration of comparators 7 Procedure |
| 11 | 8 Test report |
Related products
-
ISO 8503-2:2012
Preparation of steel substrates before application of paints and related products — Surface roughness characteristics…
