BS ISO 16239:2013
$102.76
Metric series wires for measuring screw threads
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 16 |
This International Standard specifies the material, metric series nominal diameters, diameter tolerances, and designation for screw thread measuring wires.
This International Standard is applicable to the measurement of the pitch diameters of ISO general purpose metric screw threads (M), Unified screw threads (UN), Whitworth pipe threads (G, R), and ISO metric trapezoidal screw threads (Tr) with standard pitches. These wires are intended for use on screw threads with a small lead angle, less than 5°, and are mainly used to calibrate the pitch diameters of thread plug gauges.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_4 Section sec_5 1 Scope 2 Normative references 3 Terms and definitions 4 Reference temperature 5 Material, hardness, and surface finish |
| 8 | Section sec_6 Section sec_6.1 Table tab_1 Section sec_6.2 Section sec_6.3 Section sec_6.4 6 Nominal diameters of best-size wires 6.1 Wires for ISO general purpose metric screw threads (M) 6.2 Wires for Unified screw threads (UN) 6.3 Wires for Whitworth pipe threads (G, R) 6.4 Wires for ISO metric trapezoidal screw threads (Tr) |
| 9 | Table tab_2 Table tab_3 Table tab_4 |
| 10 | Section sec_7 Table tab_5 Section sec_8 Section sec_8.1 Section sec_8.2 7 Tolerances of wires 8 Measurement methods for wires 8.1 Measuring the actual diameters of each wire 8.2 Determination of the difference of the actual diameters around a wire |
| 11 | Table tab_a Figure fig_1 Table tab_b Figure fig_2 |
| 12 | Section sec_9 9 Designation |
