BSI 19/30400056 DC:2019 Edition
$13.70
BS EN 15199-3. Petroleum products. Determination of boiling range distribution by gas chromatography method – Part 3. Crude oil
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 40 |
This document describes a method for the determination of the boiling range distribution of petroleum products by capillary gas chromatography using flame ionization detection. The standard is applicable to crude oils. The boiling range distribution and recovery to C100 or C120 can be determined.
Two procedures are described: single and dual analysis mode. The basis of each is the calculation procedure as described in Annex� A.
Procedure A (or Single analysis mode) determines the boiling range through C100 or C120 in a single analysis
Procedure B (or Dual analysis mode) combines procedure A with the boiling point distribution from C1 up to C9 using the Detailed Hydrocarbon Analysis (DHA) according EN� 15199�?’4. The results of both analyses are merged into one boiling point distribution.
There is no specific precision statement for the combined results obtained by procedure B. For the precision of the boiling range distribution according to procedure B the precision statements of procedure A and EN� 15199�?’4 apply. No precision has been determined for the results after merging.
For the purpose of this European Standard, the terms �?o% (m/m)�?? and �?o% (V/V)�?? are used to represent the mass fraction, ��, and the volume fraction, ��, of a material respectively.
This document describes the determination of boiling range distribution of materials with initial boiling points (IBP) below 100� ��C and final boiling points (FBP) above 750� ��C. For testing materials with initial boiling points (IBP) above 100� ��C and final boiling point (FBP) below 750� ��C, Part 1 of the standard may be used. For testing materials with initial boiling points (IBP) above 100� ��C and final boiling point (FBP) above 750� ��C, Part 2 of the standard may be used. Part 4 is used for the determination of the boiling range distribution of hydrocarbons up to n-nonane in crude oil.
Use of this European Standard may involve hazardous materials, operations and equipment. This European Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
