BSI PD CEN/TS 17991:2023

$102.76

Statistical verification of partial factors for buildings according to Eurocode EN 1993-1-1 Annex E

Published By	Publication Date	Number of Pages
BSI	2023	18

Guaranteed Safe Checkout

Categories: 91.010.30 - Technical aspects, BSI

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document provides requirements for the statistical distribution of material properties and dimensional parameters of structural steel products, allowing the proof of consistency of the safety approach of the properties of the product standards compared to those of the design standards for the design of steel buildings. It also describes the evaluation procedures for the verification of the compliance of structural steels with these requirements. This document applies for the following structural steel products intended for buildings: hot rolled and welded I- and H-sections, hot rolled plates rolled on a reversing mill, sheets/plates cut from hot-rolled wide strip and hot finished and cold formed welded structural hollow sections. It is intended to be used as a background document to support the assessment of the partial factors for steel constructions (as detailed in EN 1993-1-1). This document can be used for neither product ordering nor certification. NOTE The background of statistical requirements on mechanical properties and geometrical parameters is detailed in EN 1993-1-1:2022, Annex E.

PDF Catalog

PDF Pages	PDF Title
2	undefined
6	1 Scope 2 Normative references 3 Terms and definitions
7	4 Statistical verification of partial factors for buildings – Requirements on the statistical distribution of mechanical properties and products dimensions 4.1 General
8	4.2 Practical procedure and permissible deviations 4.3 Methodology of statistical verification 5 Other methods for the verification of partial factors for buildings 6 Procedures for the different steel products 6.1 General
9	6.2 Hot-rolled sections 6.2.1 General 6.2.2 Mechanical and geometrical requirements for statistical verification
10	6.2.3 Non-statistical verification 6.3 Hot rolled plates rolled on a reversing mill 6.3.1 General 6.3.2 Mechanical requirements for statistical verification for fixed thickness tolerance classes according to EN 10029 and non-statistical verification for hot rolled plates rolled on a reversing mill
11	6.4 Sheets/plates cut from hot-rolled wide strip 6.4.1 General 6.4.2 Mechanical and geometrical requirements for statistical verification
12	6.4.3 Non-statistical verification for sheets/plates cut from hot-rolled wide strip 6.5 Hot finished and cold formed welded hollow sections
13	7 Sampling and testing 7.1 Location of samples and orientation of test pieces for mechanical tests 7.2 Sampling period and population 7.3 Tensile test
14	Annex A (informative)Matrix of possible combinations of X5 % and X0,12 % criteria for sections