FL EnergyCode 2010
$13.00
Florida Building Code, Energy Conservation
| Published By | Publication Date | Number of Pages |
| FL | 2010 | 131 |
This is a fully integrated code based on the 2009 IECC.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | FLORIDA BUILDING CODE 2010 ENERGY CONSERVATION |
| 2 | FLORIDA BUILIDNG CODE 2010 ENERGY CONSERVATION TITLE PAGE |
| 3 | COPYRIGHT |
| 4 | PREFACE |
| 6 | TABLE OF CONTENTS |
| 8 | CHAPTER 1 ADMINISTRATION PART 1—SCOPE AND APPLICATION SECTION 101 SCOPE AND GENERAL REQUIREMENTS |
| 10 | TABLE 101.4.1 NONEXEMPT EXISTING BUILDINGSa SECTION 102 ALTERNATE MATERIALS—METHOD OF CONSTRUCTION, DESIGN OR INSULATING SYSTEMS PART 2—ADMINISTRATION AND ENFORCEMENT SECTION 103 CONSTRUCTION DOCUMENTS |
| 11 | TABLE 103.2.1 INDEX TO CODE COMPLIANCE FORMS |
| 12 | SECTION 104 INSPECTIONS SECTION 105 VALIDITY SECTION 106 REFERENCED STANDARDS SECTION 107 FEES RESERVED SECTION 108 STOP WORK ORDER |
| 13 | SECTION 109 BOARD OF APPEALS RESERVED SECTION 110 REPORTING TABLE 110.2 REPORTING SCHEDULE |
| 14 | CHAPTER 2 DEFINITIONS SECTION 201 GENERAL SECTION 202 GENERAL DEFINITIONS |
| 26 | CHAPTER 3 DESIGN CRITERIA SECTION 301 CLIMATE ZONES |
| 27 | TABLE 301.1 CLIMATE ZONES, MOISTURE REGIMES, AND WARM-HUMID DESIGNATIONS BY COUNTY |
| 28 | SECTION 302 DESIGN CONDITIONS SECTION 303 MATERIALS, SYSTEMS AND EQUIPMENT TABLE 303.1.3(1) DEFAULT GLAZED FENESTRATION U-FACTOR TABLE 303.1.3(2) DEFAULT DOOR U-FACTORS TABLE 303.1.3(3) DEFAULT GLAZED FENESTRATION SHGC |
| 29 | TABLE 303.2 INSULATION INSTALLATION STANDARDS TABLE 303.2.1 R-VALUES OF COMPRESSED INSULATION SECTION 304 MATERIALS TESTING AND THERMAL PROPERTIES |
| 32 | CHAPTER 4 RESIDENTIAL ENERGY EFFICIENCY SECTION 401 GENERAL SECTION 402 BUILDING THERMAL ENVELOPE |
| 33 | TABLE 402.1.1 COMPONENT EFFCIENCIES REQUIREDa, l TABLE 402.1.1.3 EQUIVALENT U-FACTORSa, f.g |
| 34 | TABLE 402.2.5(1) STEEL-FRAME CEILING, WALL AND FLOOR INSULATION (R-VALUE) TABLE 402.2.5(2) STEEL FRAME WALL INSULATION R-VALUE FOR 24 INCH SPACING OF STUDS |
| 36 | TABLE 402.4.2 AIR BARRIER AND INSULATION INSPECTION COMPONENT CRITERIA SECTION 403 SYSTEMS |
| 39 | TABLE 403.4.3.2 MINIMUM PERFORMANCE STANDARDS WATER HEATING EQUIPMENT: FIRED STORAGE WATERHEATER MINIMUM ENERGY FACTORS (EF) |
| 41 | SECTION 404 ELECTRICAL POWER AND LIGHTING SYSTEMS SECTION 405 SIMULATED PERFORMANCE ALTERNATIVE (Performance) |
| 43 | FIGURE 405.6.1 ACCEPTABLE ATTIC RADIANT BARRIER CONFIGURATIONS |
| 46 | CHAPTER 5 COMMERCIAL ENERGY EFFICIENCY SECTION 501 GENERAL SECTION 502 BUILDING ENVELOPE REQUIREMENTS |
| 47 | TABLE 502.1.1.1 (1) ENVELOPE PRESCRIPTIVE MEASURES FOR SHELL BUILDINGSa, b EQUATION 5-1 |
| 48 | TABLE 502.1.1.1 (2) ENVELOPE PRESCRIPTIVE MEASURES FOR RENOVATIONS AND ALTERATIONS1 SECTION 503 BUILDING MECHANICAL SYSTEMS |
| 52 | TABLE 503.2.3(1) UNITARY AIR CONDITIONERS AND CONDENSING UNITS, ELECTRICALLY OPERATED, MINIMUM EFFICIENCY REQUIREMENTS |
| 53 | TABLE 503.2.3(2) UNITARY AND APPLIED HEAT PUMPS, ELECTRICALLY OPERATED, MINIMUM EFFICIENCY REQUIREMENTS |
| 54 | TABLE 503.2.3(2)—continued UNITARY AIR CONDITIONERS AND CONDENSING UNITS, ELECTRICALLY OPERATED, MINIMUM EFFICIENCY REQUIREMENTS |
| 55 | TABLE 503.2.3(3) PACKAGED TERMINAL AIR CONDITIONERS AND PACKAGED TERMINAL HEAT PUMPS, SINGLE PACKAGED VERTICAL AIR CONDITIONERS AND HEAT PUMPS, ROOM AIR CONDITIONERS, AND ROOM AIR CONDITIONER HEAT PUMPS MINIMUM EFFICIENCY REQUIREMENTS |
| 56 | TABLE 503.2.3(4) WARM AIR FURNACES AND COMBINATION WARM AIR FURNACES/AIR-CONDITIONING UNITS, WARM AIR DUCT FURNACES AND UNIT HEATERS, MINIMUM EFFICIENCY REQUIREMENTS |
| 57 | TABLE 503.2.3(5) BOILERS, GAS- AND OIL-FIRED, MINIMUM EFFICIENCY REQUIREMENTS TABLE 503.2.3(6) CONDENSING UNITS, ELECTRICALLY OPERATED, MINIMUM EFFICIENCY REQUIREMENTS |
| 58 | TABLE 503.2.3(7) WATER CHILLING PACKAGES, EFFICIENCY REQUIREMENTSa |
| 59 | TABLE 503.2.3(8) PERFORMANCE REQUIREMENTS FOR HEAT REJECTION EQUIPMENT |
| 60 | TABLE 503.2.7.1 MINIMUM DUCT INSULATION R-VALUES, HEATING AND COOLING SUPPLY AND RETURN DUCTS |
| 64 | TABLE 503.2.7.2 DUCT SYSTEM CONSTRUCTION AND SEALING |
| 65 | TABLE 503.2.7.2 —continued DUCT SYSTEM CONSTRUCTION AND SEALING |
| 66 | TABLE 503.2.7.2—continued DUCT SYSTEM CONSTRUCTION AND SEALING |
| 67 | TABLE 503.2.8 MINIMUM PIPE INSULATION (in.)1 |
| 68 | TABLE 503.2.10.1(1) FAN POWER LIMITATIONa, b TABLE 503.2.10.1(2) FAN POWER LIMITATION |
| 71 | TABLE 503.4.7 MAXIMUM HOT GAS BYPASS CAPACITY SECTION 504 SERVICE WATER HEATING (Mandatory) |
| 72 | SECTION 505 ELECTRICAL POWER AND LIGHTING SYSTEMS (Mandatory) TABLE 505.2.1.2 SPATIAL CONTROL LIMITATION |
| 73 | TABLE 504.2 MINIMUM PERFORMANCE OF WATER-HEATING EQUIPMENT |
| 76 | TABLE 505.6.2(1) EXTERIOR LIGHTING ZONES SECTION 506 TOTAL BUILDING PERFORMANCE |
| 77 | TABLE 505.5.3 INTERIOR LIGHTING POWER DENSITIES (LPD) USING THE SPACE-BY-SPACE METHOD |
| 78 | TABLE 505.5.3—continued INTERIOR LIGHTING POWER DENSITIES (LPD) USING THE SPACE-BY-SPACE METHOD |
| 80 | TABLE 505.6.2(2) INDIVIDUAL LIGHTING POWER ALLOWANCES FOR BUILDING EXTERIORS |
| 81 | TABLE 505.7.5 MINIMUM NOMINAL EFFICIENCY FOR GENERAL PURPOSE DESIGN A AND DESIGN B MOTORS1 |
| 82 | CHAPTER 6 REFERENCED STANDARDS AABC AAMA ACCA ADC AHAM |
| 83 | AHRI AMCA ANSI APSP |
| 84 | ARDM ASHRAE ASME ASTM |
| 85 | CRRC CSA CTI |
| 86 | DOE FLORIDA CODE FSEC GAMA IESNA |
| 87 | ISO NAIMA NEBB NEMA NFPA NFRC |
| 88 | SMACNA SPRI SRCC UL US—FTC WDMA |
| 90 | APPENDIX A JURISDICTIONAL DATA |
| 102 | NORMATIVE APPENDIX B CRITERIA FOR COMPUTER MODELING FOR PERFORMANCE-BASED CODE COMPLIANCE B-1.0 RESIDENTIAL B-1.1 CALCULATION PROCEDURE EQUATION – EQUIPMENT CALCULATION OF END USE ENERGY LOADS FOR CODE COMPLIANCE DETERMINATION |
| 103 | TABLE B-1.1.2(1) SPECIFICATIONS FOR THE STANDARD REFERENCE AND PROPOSED DESIGNS |
| 104 | TABLE B-1.1.2(1)—continued SPECIFICATIONS FOR THE STANDARD REFERENCE AND PROPOSED DESIGNS |
| 105 | TABLE B-1.1.2(1)—continued |
| 106 | TABLE B-1.1.2(2) DEFAULT STANDARD REFERENCE DESIGN HOMEa, b, c, d TABLE B-1.1.3 COEFFICIENTS ‘a’ AND ‘b’ B-1.2 CALCULATION SOFTWARE TOOLS B-2.0 COMMERCIAL AND RESIDENTIAL GREATER THAN OR EQUAL TO 3 STORIES B-2.1 CALCULATION PROCEDURE B-2.2 BUILDING SPECIFICATIONS B-2.3 CALCULATION SOFTWARE TOOLS |
| 107 | B-2.6 HVAC SYSTEMS |
| 108 | TABLE B-2.2 SPECIFICATIONS FOR THE STANDARD REFERENCE AND PROPOSED DESIGNS |
| 109 | TABLE B-2.2—continued SPECIFICATIONS FOR THE STANDARD REFERENCE AND PROPOSED DESIGNS |
| 110 | TABLE B-2.2—continued SPECIFICATIONS FOR THE STANDARD REFERENCE AND PROPOSED DESIGNS |
| 112 | FIGURE B-2.6.1 HVAC SYSTEMS MAP |
| 113 | TABLE B-2.6.1 SPECIFICATIONS FOR THE STANDARD REFERENCE DESIGN HVAC SYSTEM DESCRIPTIONS |
| 114 | TABLE B-2.6.1A NUMBER OF CHILLERS TABLE B-2.6.1B WATER CHILLER TYPES |
| 116 | APPENDIX C FORMS |
| 117 | ENERGY PERFORMANCE LEVEL (EPL) DISPLAY CARD |
| 118 | FORM 400D-2010 DESUPERHEATER, HEAT RECOVERY UNIT (HRU) WATER HEATER EFFICIENCY CERTIFICATION |
| 119 | FORM 402-2010 RESIDENTIAL BUILDING THERMAL ENVELOPE APPROACH |
| 120 | TABLE 402A TABLE 402B MANDATORY REQUIREMENTS |
| 121 | FORM 502-2010 CHAPTER 5 — BUILDING ENVELOPE PRESCRIPTIVE METHOD |
| 124 | INDEX |
| 130 | IECC TOOLS |
| 131 | COMMENTARY AND STUDY TOOLS |
