IEEE 1017-1991

$42.79

IEEE Recommended Practice for Field Testing Electric Submersible Pump Cable

Published By	Publication Date	Number of Pages
IEEE	1991	15

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Revision Standard – Inactive-Withdrawn. Withdrawn Standard. Withdrawn Date: Dec 09, 1997. No longer endorsed by the IEEE. Revision of IEEE Std 1017-1985 Procedures and test-voltage values for acceptance and maintenance testing of electrical submersible pump (ESP) cable systems are presented. This recommended practice applies to cable systems rated 3000 V and 5000 V and is intended only for this special-purpose cable. The intent is to provide uniform test procedures an guidelines for evaluation of the test results.

PDF Catalog

PDF Pages	PDF Title
7	1 Introduction 1.1 Background 1.2 Purpose 1.3 Scope
8	2 References 3 Definitions 3.1 Current 3.2 Voltage 3.3 Electrical Tests 3.4 Cable
9	Typical Electric Submersible Pump Installation
10	General Considerations 4.1 Environmental Influences 4.1.1 Temperature 4.1.2 Environmental Conditions Well Liquids and Gases 4.2 Test Equipment DC High Potential Tester (hi-pot) Insulation Resistance Meter Safety of Personnel 4.4 Equipment Setup
11	Special Test Equipment Time Domain Reflectometer (TDR) 4.5.2 Thumper Bridge Type Fault Locater 4.5.4 DC Bum 4.6 Equipment Maintenance DC Hi-Pot Test Methods 5.1 Precautions
12	5.2 Procedures High-Voltage DC Cable Test Connections
13	Step Voltage Testing of ESP Cable Test Voltages for ESP Cable
14	Evaluation of Results 6.1 Current-Time Relationship 6.2 Interpretation Leakage Current in Good Cable Leakage Current in Bad Cable
15	6.3 Dielectric Failure 6.4 Current Comparison Continuity Tests Mechanical Intergrity