IEEE 1017 1992
$30.88
IEEE Recommended Practice for Field Testing Electric Submersible Pump Cable
Published By | Publication Date | Number of Pages |
IEEE | 1992 | 15 |
Revision Standard – Inactive – Withdrawn. Withdrawn Standard. Withdrawn Date: Dec 09, 1997. No longer endorsed by the IEEE. Revision of IEEE Std 1017-1985 Procedures and test-voltage values for acceptance and maintenance testing of electrical submersible pump (ESP) cable systems are presented. This recommended practice applies to cable systems rated 3000 V and 5000 V and is intended only for this special-purpose cable. The intent is to provide uniform test procedures an guidelines for evaluation of the test results. You will receive an email from Customer Service with the URL needed to access this publication online.
PDF Catalog
PDF Pages | PDF Title |
---|---|
7 | 1 Introduction 1.1 Background 1.2 Purpose 1.3 Scope |
8 | 2 References 3 Definitions 3.1 Current 3.2 Voltage 3.3 Electrical Tests 3.4 Cable |
9 | Typical Electric Submersible Pump Installation |
10 | General Considerations 4.1 Environmental Influences 4.1.1 Temperature 4.1.2 Environmental Conditions Well Liquids and Gases 4.2 Test Equipment DC High Potential Tester (hi-pot) Insulation Resistance Meter Safety of Personnel 4.4 Equipment Setup |
11 | Special Test Equipment Time Domain Reflectometer (TDR) 4.5.2 Thumper Bridge Type Fault Locater 4.5.4 DC Bum 4.6 Equipment Maintenance DC Hi-Pot Test Methods 5.1 Precautions |
12 | 5.2 Procedures High-Voltage DC Cable Test Connections |
13 | Step Voltage Testing of ESP Cable Test Voltages for ESP Cable |
14 | Evaluation of Results 6.1 Current-Time Relationship 6.2 Interpretation Leakage Current in Good Cable Leakage Current in Bad Cable |
15 | 6.3 Dielectric Failure 6.4 Current Comparison Continuity Tests Mechanical Intergrity |