IEEE 1017.4-2023
$37.38
IEEE Recommended Practice for Testing and Rating of Electrical Submersible Pump Motors (Published)
Published By | Publication Date | Number of Pages |
IEEE | 2023 |
New IEEE Standard – Active. Procedures and test values for testing and rating of electrical submersible pump (ESP) motors as well as installation and handling practices are specified in this document. The specified procedures and test values apply to ESP motor systems rated 3kV through 8kV (phase to phase).
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 1017.4ā¢-2023 Front cover |
2 | Title page |
4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
8 | Participants |
10 | Introduction |
12 | Contents |
14 | 1.āOverview 1.1āScope 1.2āPurpose 1.3āWord usage |
15 | 2.āNormative references 3.āDefinitions |
18 | 4.āElectrical measurements 4.1āGeneral 4.2āPower supply used for electrical measurements |
19 | 4.3āInstrument selection 4.4āInstrument transformers 4.5āVoltage 4.6āCurrent 4.7āPower 4.8āResistance |
20 | 5.āMechanical measurements 5.1āMechanical-output measurement methods 5.2āBrake 5.3āDynamometer 6.āGeneral considerations 6.1āEnvironmental influences |
21 | 6.2āTest equipment |
22 | 6.3āEquipment setup 6.4āSpecial fault-locating test equipment |
23 | 6.5āEquipment maintenance 7.āMotor model and design parameters 7.1āBasic data |
25 | 8.āRoutine tests 8.1āTerminal/stator winding resistance |
26 | 8.2āInsulation resistance test 8.3āSurge comparison test 8.4āPhase rotation 8.5āHipot test 8.6āFactory acceptance test (idle test/no load test) |
27 | 8.7āString test |
28 | 8.8āMachine vibration measurements 9.āMotor design performance tests 9.1āBasis of tests 9.2āLoad test |
31 | 9.3āTests with rotor locked 9.4āCorrection to a specified temperature |
32 | 10.āEfficiency tests 10.1āApplicable test standards 10.2āTypes of losses |
35 | 11.āSurge comparison testing 11.1āTurn-turn insulation failures |
36 | 11.2āDescription 11.3āTest conditions |
37 | 11.4āHigh frequency test levels for new coils |
38 | 12.āDC hi-pot test methods 12.1āOverview 12.2āPrecautions 12.3āDC high potential tester (hi-pot) |
39 | 12.4āEquipment setup 12.5āProcedures |
40 | 12.6āEvaluation of dc hi-pot test results 13.āVibration analysis and dynamic balancing 13.1āGeneral |
41 | 13.2āVibration reduction |
42 | 14.āMotor expected design life (thermal insulation rating) testing 14.1āInsulation aging concepts |
43 | 14.2āLimiting temperatures and their measurements for EIS |
44 | 14.3āTemperature classes of EIS |
45 | 15.āCharacteristics of connected drives |
47 | AnnexĀ A (informative) Bibliography |
49 | Back cover |