Shopping Cart

No products in the cart.

IEEE 1301.3-1992

$69.58

IEEE Standard for a Metric Equipment Practice for Microcomputers – Convection-Cooled with 2.5 mm Connectors

Published By Publication Date Number of Pages
IEEE 1992 29
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Inactive-Reserved. Recommendations provide guidance in the implementation of the generic standard, IEEE Std 1301-1991, and the connector-related standards, such as IEEE Std 1301.1-1991 and IEEE Std 1301.3-1992. This recommended practice may be applied in all fields of electronics where equipment and installations are required to conform to a metric modular order. The IEEE 1301 metric equipment practices are in accordance with IEC 917 (1988) and IEC 917-0 (1989), including cabinet, rack, subracks, printed boards, and common connector-dependent dimensions for connector pitches of 2.5, 2.0, 1.5, 1.0, and 0.5 mm.

PDF Catalog

PDF Pages PDF Title
1 Title Page
3 Introduction
4 Participants
5 CONTENTS
6 1. Overview
1.1 Scope
1.2 Purpose
1.3 Dimensions
1.4 Coordination dimensions
7 1.5 Environmental requirements
1.6 Conformance with this standard
2. References
9 3. Word usage, definitions, and abbreviations
3.1 Special word usage
3.2 Definitions
3.3 Abbreviations
10 4. Dimensional nomenclature
4.1 Dimensional location nomenclature
4.2 Dimensional nomenclature, heights
11 4.3 Dimensional nomenclature, widths
12 4.4 Dimensional nomenclature, depths
4.5 Dimensional nomenclature, mounting pitches
13 5. General arrangement
14 6. Subracks
7. Backplane design and mounting positions
7.1 Rigidity
7.2 Dimension
19 8. Plug-in units
26 Annex A Tolerances with 2.5 mm connector and IEEE 1301 metric equipment
IEEE 1301.3-1992
$69.58