IEEE 293-1969

$57.96

IEEE Test Procedure for Single-Degree-of-Freedom Spring-Restrained Rate Gyros

Published By	Publication Date	Number of Pages
IEEE	1969	17

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

New IEEE Standard – Active. Recommended rate gyro test procedures derived from those currently in use, including test conditions to be considered, are compiled. In some cases alternate methods for measuring a performance characteristic have been included. This standard is intended to be a guide in the preparation of Section 4 of a specification that follows the format of IEEE Std 292, Specification Format for Single-Degree-of-Freedom Spring-Restrained Rate Gyros.

PDF Catalog

PDF Pages	PDF Title
4	1 Introduction Function and Application of the Rate Gyro Test Conditions and Test Equipment 3.1 Standard Test Conditions
5	3.2 Test Equipment 4 Test Procedures Examination of the Product 4.2 Impedance Test 4.3 Dielectric Test
6	4.4 Insulation Rcsistance Test 4.5 Leak Test 4.6 Polarity Test
7	4.7 Electrical Null Test Output Noise (Signal Modulation) Test 4.9 Run-UpTimeTest
8	Rotor Rotation Detector (RRD) Test Power Consumption and Current Starting and Running Test 4.12 Run-Down Time Test Rate Transfer Characteristic Test Series
9	4.14 Limit Stops Test
10	Pickoff Phase Shift Test 4.16 Switching Rate Test 4.17 Self-Test Torquer Test AccelerationSensitive Drift Rate Tests
12	Rate Sensitivity About the Spin Reference Axis Test
13	Rate Sensitivity About the Output Axis Test Angular Acceleration Sensitivity About t.he Output Axis Test
14	Dynamic Response Test Series 4.23 Warm-up TimeTest
15	Table 1 Environmental Test Guide
17	4.24 Environmental Test Series