Shopping Cart

No products in the cart.

IEEE 303-2023

$30.33

IEEE Recommended Practice for Auxiliary Devices for Rotating Electrical Machines in Class I, Division 2 and Zone 2 Locations and Class II, Division 2 and Zone 22 Locations (Published)

Published By Publication Date Number of Pages
IEEE 2023
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Revision Standard – Active. This recommended practice applies to the application and installation procedures of auxiliary devices in or on electric rotating machines that are employed in hazardous locations classified as Class I, Division 2 and Zone 2 and Class II, Division 2 and Zone 22 under commonly used worldwide regulations. These regulations are: the National Electrical Code® (NEC®); the Canadian Electrical Code (CE Code); and combined practices of the International Electrotechnical Commission (IEC). Included is a list of source documents, definitions and nomenclature. Devices include terminal housings, heaters, surge protection, power factor correction capacitors, shaft bonding (shaft grounding), and enclosures. Special marking requirements are also discussed.

PDF Catalog

PDF Pages PDF Title
1 IEEE Std 303™-2023 Front cover
2 Title page
4 Important Notices and Disclaimers Concerning IEEE Standards Documents
8 Participants
9 Introduction
10 Contents
11 1. Overview
1.1 Scope
1.2 Purpose
1.3 Word usage
12 2. Normative references
13 3. Definitions, acronyms, and abbreviations
3.1 Definitions
17 3.2 Acronyms and abbreviations
4. Auxiliary device categories and protection techniques
4.1 General
4.2 Arcing/sparking components
18 4.3 Protection techniques
4.4 Non-arcing/sparking components
19 5. Wiring methods and materials
5.1 Factory-installed internal wiring
5.2 Factory-installed external wiring
6. Device and component installation recommendations
6.1 Terminal housing
20 6.2 Space heaters
21 6.3 Bearing oil heaters
22 6.4 Surge protection
6.5 Power factor correction capacitors
6.6 Shaft bonding
23 7. Enclosures
7.1 Multi-sectioned requirements
7.2 Purging and/or pressurizing equipment
7.3 Selection of enclosures
24 Annex A (informative) Bibliography
26 Back cover
IEEE 303-2023
$30.33