IEEE 386 2016
$52.54
IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Rated 2.5 kV through 35 kV
Published By | Publication Date | Number of Pages |
IEEE | 2016 | 81 |
Revision Standard – Active. Definitions, service conditions, ratings, interchangeable construction features, and tests are established for loadbreak and deadbreak separable insulated connector systems for use on power distribution systems rated 2.5 kV through 35 kV and 900 A or less.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 386™-2016 Front cover |
2 | Title page |
4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
7 | Participants |
9 | Introduction |
10 | Contents |
12 | List of Figures |
14 | List of Tables |
15 | IMPORTANT NOTICE 1. Scope 2. Normative references |
16 | 3. Definitions, abbreviations, and acronyms 3.1 Definitions |
20 | 3.2 Abbreviations and acronyms 4. Service conditions 4.1 Usual service conditions 4.2 Unusual service conditions 5. Ratings and characteristics 5.1 Voltage ratings and characteristics |
21 | 5.2 Current ratings and characteristics |
22 | 6. Construction 6.1 Identification |
23 | 6.2 Operating means |
24 | 6.3 Shielding 6.4 Interchangeability 6.5 Test point |
25 | 6.6 Hold-down bails 6.7 Bushing well stud torque withstand 6.8 Thermal cycle withstand 7. Testing 7.1 Production tests 7.2 Design tests |
50 | 7.3 Test conditions 7.4 Partial discharge test |
51 | 7.5 Dielectric tests |
54 | 7.6 Short-time current test 7.7 Switching test |
58 | 7.8 Fault-closure test |
60 | 7.9 Current-cycling test for uninsulated components of 600-A and 900-A connectors |
61 | 7.10 Current-cycling test for 200-A insulated connectors |
63 | 7.11 Current-cycling test for 600-A and 900-A insulated connectors |
64 | 7.12 Accelerated sealing life test |
65 | 7.13 Cable pull-out test (tensile strength) 7.14 Operating-force test for separable connectors with an operating eye 7.15 Operating-eye test 7.16 Test point cap test |
66 | 7.17 Test point tests 7.18 Shielding test 7.19 Bushing well stud torque withstand test 7.20 Thermal cycle withstand test |
67 | 7.21 Tee separable insulated connector interchangeability test |
69 | Annex A (informative) Trial use guide for testing of separable connector lubricants A.1 Test for lubricants used on separable insulated connector interfaces A.2 Operating force test A.3 Accelerated aging test |
70 | A.4 Dielectric tests A.5 Switching test A.6 Compatibility A.7 Physical properties |
72 | Annex B (informative) IEC versus IEEE ratings |
78 | Annex C (informative) DC withstand test voltage reference |
79 | Annex D (informative) Bibliography |
81 | Back cover |