IEEE 404-2012

$57.42

IEEE Standard for Extruded and Laminated Dielectric Shielded Cable Joints Rated 2.5 kV to 500 kV

Published By	Publication Date	Number of Pages
IEEE	2012

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Revision Standard – Active. Electrical ratings and test requirements of cable joints used with extruded and laminated dielectric shielded cable rated in preferred voltage steps from 2.5 kV to 500 kV are established in this standard. In addition, test requirements for joint metallic-shield and jacketing components are defined. A variety of common joint constructions are also defined. This standard has been designed to provide uniform testing procedures that can be used by manufacturers and users to evaluate the ability of underground power cable joints, and associated metallic-shields and jacketing components, to perform reliably in service.

PDF Catalog

PDF Pages	PDF Title
1	IEEE Std 404-2012 Front Cover
3	Title page
6	Notice to users Laws and regulations Copyrights Updating of IEEE documents Errata Patents
8	Participants
10	Introduction
11	Contents
13	Important notice 1. Overview 1.1 Scope 2. Normative references
15	3. Definitions 3.1 Cable joint categories 3.2 Joint constructions
16	3.3 Other terms 4. Service conditions
17	5. Ratings 5.1 Voltage 5.2 Current and temperature
19	6. General requirements 6.1 Identification
20	6.2 Shielding 6.3 Jacket seal 6.4 Sheath/shield sectionalizers 7. Design testing
21	7.1 Design tests and testing sequence for all joint types 7.2 Design test conditions
23	7.3 Dielectric integrity tests
27	7.4 Voltage tests
29	7.5 Short-time current test 7.6 Cyclic aging test for extruded dielectric and transition joints
32	7.7 High-voltage time test 7.8 Sectionalizer tests
33	7.9 Shielding test
34	7.10 Joint metallic-shield and jacketing components
37	7.11 Connector thermal and mechanical tests 8. Routine production testing
38	8.1 Premolded and single-component cold-shrink joints 8.2 Heat-shrink and multi-component cold-shrink joints
39	8.3 Elastomeric taped joint components
42	Annex A (informative) Typical values of heat-shrinkable and multi-component cold-shrink joint component tests and sampling rates
43	Annex B (informative) Typical values of elastomeric taped joint component tests and sampling rates
44	Annex C (informative) DC test voltage reference
46	Annex D (informative) Bibliography