IEEE 519-2022(Redline)

$43.33

IEEE Standard for Harmonic Control in Electric Power Systems (Redline)

Published By	Publication Date	Number of Pages
IEEE	2022

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Revision Standard – Active. Goals for the design of electrical systems that include both linear and nonlinear loads are established in this standard. The voltage and current waveforms that may exist throughout the system are described, and waveform distortion goals for the system designer are established. The interface between sources and loads is described as the point of common coupling and observance of the design goals will reduce interference between electrical equipment. This standard addresses steady-state limitations. Transient conditions exceeding these limitations may be encountered. This document sets the quality of power that is to be provided at the point of common coupling. This document does not cover the effects of radio-frequency interference; however, guidance is offered for wired telephone systems.

PDF Catalog

PDF Pages	PDF Title
1	IEEE Std 519-2022 Front Cover
2	Title page
4	Important Notices and Disclaimers Concerning IEEE Standards Documents
8	Participants
10	Introduction
11	Contents
12	1. Overview 1.1 Scope
13	1.2 Purpose
14	1.3 Word usage 2. Normative references
15	3. Definitions, acronyms, and abbreviations 3.1 Definitions
16	3.2 Acronyms and abbreviations 4. Harmonic measurements 4.1 Measurement window width
17	4.2 Very short time harmonic measurements 4.3 Short time harmonic measurements 4.4 Statistical evaluation 5. Harmonic distortion limits
18	5.1 Voltage distortion limits 5.2 Current distortion limits
19	5.3 Current distortion limits for systems nominally rated 120 V through 69 kV
20	5.4 Current distortion limits for systems nominally rated above 69 kV through 161 kV
21	5.5 Current distortion limits for systems nominally rated above 161 kV
22	5.6 Recommendations for increasing harmonic current limits
24	Annex A (informative) Interharmonic voltage limits A.1 Premise A.2 Limits rationale A.2.1 Limit curves for countries not adopting ripple control
25	A.2.2 Limits for countries adopting ripple control
26	A.3 Summary of the work done by the interharmonic distortion task force
27	Annex B (informative) Telephone influence factor (TIF)
28	B.1 Guidelines for I-T product
29	Annex C (informative) Limits on commutation notches C.1 Recommended limits on commutation notches
30	Annex D (informative) Bibliography
31	Back Cover