IEEE 802.16s 2017
$33.04
IEEE Standard for Air Interface for Broadband Wireless Access Systems–Amendment 4: Fixed and Mobile Wireless Access in Channel Bandwidth up to 1.25 MHz
Published By | Publication Date | Number of Pages |
IEEE | 2017 | 42 |
Amendment Standard – Superseded. WirelessMAN-OFDMA TDD operation in exclusively licensed spectrum with channel bandwidth from 100 kHz up to 1.25 MHz, including 1 MHz explicitly, is specified. This amendment targets operation in the 700 MHz band but also supports operation in otherre VHF/UHF bands. The project amends Clause 12 of IEEE Std 802.16-2012, adding a new system profile and amending otherre clauses as required to support the narrower channel widths. The range and data rate supported by the added profile are commensurate with those of the base standard, as scaled by the reduced channel bandwidth.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 802.16s-2017 Front cover |
2 | Title page |
4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
7 | Participants |
8 | Introduction |
9 | Contents |
14 | IEEE Standard for Air Interface for Broadband Wireless Access Systems—Amendment 4: Fixed and Mobile Wireless Access in Channel Bandwidth up to 1.25 MHz 3. Definitions |
15 | 6. MAC common part sublayer 6.3 Data/Control plane 6.3.2.1 MAC header formats 6.3.2.1.1.1 Relay MAC header format 6.3.2.1.1.2 Generic MAC header format for DL-MAP and UL-MAP MAC messages when channel bandwidth is less than 1.25 MHz 6.3.2.3 MAC management messages |
16 | 6.3.2.3.2 DL-MAP (Downlink map) message |
17 | 6.3.2.3.4 UL-MAP (UL map) message 6.3.3 Construction and transmission of MAC PDUs 6.3.3.5.2 CRC32 calculation for OFDMA mode 6.3.3.5.3 CRC8 calculation for OFDMA mode |
18 | 8. Physical layer (PHY) 8.1 WirelessMAN-SC PHY specification 8.1.3 Duplexing techniques and PHY Type parameter encodings 8.1.4 DL PHY 8.1.4.4.7 DL modulation 8.1.5 UL PHY 8.1.5.5.7 UL modulation |
19 | 8.4 WirelessMAN-OFDMA PHY 8.4.2 OFDMA symbol description, symbol parameters and transmitted signal 8.4.2.3 Primitive parameters Table 8-104a— Sampling factors for channel bandwidths less than 1.25 MHz |
20 | 8.4.3 OFDMA basic terms definition 8.4.3.1 Slot and data region 8.4.3.4 OFDMA data mapping 8.4.5 Map message fields and IEs 8.4.5.1 DL-MAP PHY Synchronization field |
21 | 8.4.5.2 Frame duration codes |
22 | 8.4.5.3 DL-MAP IE format |
23 | 8.4.5.3.1 DIUC allocation 8.4.5.3.4 STC DL Zone IE format |
24 | 8.4.5.4 UL-MAP IE format |
26 | 8.4.5.4.1 UIUC allocation |
27 | 8.4.5.4.2 PAPR Reduction/Safety Zone/Sounding Zone Allocation IE 8.4.5.4.3 CDMA Allocation UL-MAP IE format |
28 | 8.4.5.4.7 UL Zone Switch IE format 8.4.6 OFDMA subcarrier allocations |
29 | 8.4.6.1 Downlink (DL) 8.4.6.1.1 Preamble for channel bandwidths greater than or equal to 1.25 MHz 8.4.6.1.1a Preamble structure for channel bandwidths less than 1.25 MHz 8.4.6.1.2 Symbol structure |
30 | 8.4.6.1.2.7 Symbol structure for band AMC for 128-FFT for channel bandwidth less than 1.25 MHz |
31 | 8.4.6.2 Uplink (UL) 8.4.6.3 Optional adjacent subcarrier permutations for AMC |
32 | 8.4.6.3.1 AMC optional permutation 8.4.7 OFDMA ranging 8.4.7.3 Ranging codes 8.4.7.3.1 Ranging codes for reduced subcarriers for channel bandwidths from 100 kHz to 500 kHz |
33 | 8.4.14 Receiver requirements 8.4.14.1.1 Receiver sensitivity |
34 | 11. TLV encodings 11.8 SBC-REQ/RSP management message encodings 11.8.3.5.4 OFDMA SS permutation support 11.18 MOB_NBR-ADV management message encodings 11.18.2 PHY mode ID |
35 | 12. System profiles 12.9 WirelessMAN OFDMA TDD Sub-1.25 MHz channel bandwidths |
38 | 12.9.1 WirelessMAN-OFDMA Power class profiles |
42 | Back cover |