Shopping Cart

No products in the cart.

IEEE C37.60 1981

$54.71

IEEE Standard Requirements for Overhead, Pad Mounted, Dry Vault, and Submersible Automatic Circuit Reclosers and Fault Interrupters for AC Systems

Published By Publication Date Number of Pages
IEEE 1981 45
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Inactive – Superseded. This standard applies to all overhead, pad mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers and fault interrupters for rated maximum voltages above 1000 V. In order to simplify this standard where possible, the term recloser has been substituted for automatic circuit recloser or fault interrupter or both.

PDF Catalog

PDF Pages PDF Title
1 Title Page
3 Introduction
Participants
6 CONTENTS
9 1. Scope
2. References
10 3. Service Conditions
3.1 Usual Service Conditions
3.2 Unusual Service Conditions
11 4. Definitions
12 5. Rating
5.1 Rating Information
5.2 Rated Maximum Voltage
5.3 Rated Frequency
13 5.4 Rated Continuous Current
20 5.5 Rated Minimum Tripping Current (for Series-Trip Reclosers)
22 5.6 Rated Symmetrical Interrupting Current
23 5.7 Rated Symmetrical Making Current
5.8 Rated Impulse Withstand Voltage
26 5.9 Rated Control Voltage and Ranges
5.10 Rated Cable Charging Interrupting Current (where applicable)
6. Design Tests
6.1 General
27 6.2 Insulation (Dielectric Tests)
28 6.3 Interruption Tests
31 6.4 Making Current Tests
6.5 Minimum Tripping Current Tests
32 6.6 Partial Discharge Tests
6.7 Radio Influence Voltage Tests (RIV)
34 6.8 Surge Current Test; Series Coil Reclosers
6.9 Temperature Rise Test
36 6.10 Time-Current Tests
37 6.11 Mechanical Operations Tests
38 6.12 Cable Charging Current Interrupting Test
39 6.13 Transformer Magnetizing Current Interruption Test
40 6.14 Control Elements Surge Withstand Capability Tests
41 7. Production Tests
42 7.1 Reclosing and Overcurent Trip Calibration
7.2 Control, Secondary Wiring and Accessory Devices Check Tests
7.3 Dielectric Withstand Test; One Minute Dry Low Frequency
7.4 Mechanical Operations Tests
7.5 Leak Test
8. Construction Requirements
8.1 Tank Construction; Submersible or Dry Vault Reclosers
43 8.2 Grounding Provisions
8.3 Insulating Medium Quantity Indicators (Submersible Reclosers)
8.4 Oil Sampling Provisions (Submersible Reclosers)
8.5 Manual Operating Provision
44 8.6 Position Indicator
8.7 Nameplate Markings
8.8 Stored Energy Mechanism Charge Indicator
8.9 Safety Provisions
8.10 Separate Mounting of Control Apparatus
45 8.11 Counters
8.12 Conductor Terminal Sizes
8.13 Vacuum Interrupters
IEEE C37.60 1981
$54.71