IEEE C37.66 2006
$44.96
IEEE Standard Requirements for Capacitor Switches for AC Systems (1 kV to 38 kV)
Published By | Publication Date | Number of Pages |
IEEE | 2006 | 43 |
Revision Standard – Active. Required definitions, ratings, and procedures for performing design tests, production tests, and construction requirements for capacitor switches for ac systems from 1kV to 38 kV are covered. An interpretations is available at http://standards.ieee.org/findstds/interps/c37.66-2005.html
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Standard Requirements for Capacitor Switches for AC Systems (1 kV to 38 kV) |
7 | Introduction Notice to users Errata Interpretations Patents |
8 | Participants |
10 | Contents |
12 | 1. Scope 2. Normative references |
13 | 3. Definitions |
14 | 4. Service conditions 4.1 Usual service conditions 4.2 Unusual service conditions |
15 | 5. Ratings 5.1 General |
16 | 5.2 Rating information 5.3 Rated maximum voltage 5.4 Rated power frequency 5.5 Rated peak fault-making current 5.6 Rated symmetrical fault-making current |
18 | 5.7 Rated capacitive switching current 5.8 Rated peak withstand current 5.9 Rated short-time (symmetrical) withstand current and duration 5.10 Rated high-frequency transient-making current 5.11 Rated transient inrush frequency |
19 | 5.12 Rated lightning impulse withstand voltage |
20 | 5.13 Rated control voltages and ranges 6. Design tests 6.1 General |
21 | 6.2 Insulation (dielectric) tests |
23 | 6.3 Short-time current tests 6.4 Rated fault-making current tests |
25 | 6.5 Operating duty tests |
27 | 6.6 Condition of capacitor switch after short-time current tests, rated fault-making current tests, and operating duty tests (see 6.3, 6.4, and 6.5) |
28 | 6.7 Temperature rise tests |
29 | 6.8 Radio influence voltage tests |
31 | 6.9 Mechanical life tests 6.10 Control wiring tests 7. Production tests 8. Construction requirements 8.1 Grounding provision 8.2 Manual operating provision |
32 | 8.3 Position indicator 8.4 Nameplate marking |
33 | Annex A (informative) Fault handling ratings for capacitor switches Annex A (informative) Fault handling ratings for capacitor switches |
35 | Annex B (informative) Consideration of inrush current in back-to-back capacitor switching |
39 | Annex C (informative) Simultaneous opening of single-phase capacitor switches on ungrounded wye capacitor installations |
40 | Annex D (informative) Altitude correction factors |