IEEE C57.13.5-2003

$50.92

IEEE Standard of Performance and Test Requirements of Instrument Transformers of a Nominal Voltage of 115 kV and Above

Published By	Publication Date	Number of Pages
IEEE	2003	53

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

New IEEE Standard – Superseded. This standard covers the test requirements, including test sequences, criteria, methods, and documentation for instrument transformers of 115 kV nominal system and above. It is to be used a supplement to IEEE STD C57.13-1993. Besides the provision of up-to-date test requirements, the trial-use standard also provides test procedures that were not adequately covered in the previous standard.

PDF Catalog

PDF Pages	PDF Title
2	Title Page
4	Introduction Participants
6	CONTENTS
8	1. Overview 1.2 Purpose 2. References
10	3. Definitions 4. General 4.1 Insulation requirements
14	4.2 Mineral oil requirements 4.3 Requirements for accuracy and accuracy calibration systems
15	4.4 Mechanical performance requirements
16	4.5 Thermal performance requirements 4.6 Ground shield requirements 4.7 Dissolved gas and water content requirements for new oil-immersed 4.8 Endurance capability for fast high-voltage transient
17	4.9 Performance of internal arc protection 4.10 Identification of test sample in the type test report 4.11 Secondary short-circuit capability for voltage transformers 5. Test conditions
18	6. Classification of tests 6.1 Routine tests and test sequences
20	6.2 Type tests and test sequences
21	6.3 Special tests
24	7. Routine test procedures (applicable to instrument transformers) 7.1 Verification of terminal markings and polarity 7.2 Capacitance and dissipation factor test 7.3 Applied voltage test on secondary windings
25	7.4 Insulation resistance test on windings 7.5 Lightning impulse voltage test on the primary winding 7.6 Power frequency voltage withstand test
26	7.7 Partial discharge test 7.8 Dissolved gas and water content analysis for oil-immersed transformers (of a nominal system voltage 345 kV and above 7.9 Sealing test
27	7.10 Ground shield check
28	7.11 Tests on the mineral oil 8. Routine test procedures (applicable to current transformers) 8.1 Inter-turn overvoltage test
29	8.2 Accuracy test for the metering rated current transformers 8.3 Resistance measurement of relaying rated secondary windings 8.4 Performance characteristics of relaying rated current transformers
30	9. Routine test procedures (applicable to voltage transformers) 9.1 Applied voltage test on the neutral terminal 9.2 Accuracy test
31	9.3 Excitation characteristics with respect to rated voltage factor 9.4 Resistance measurement of windings 10. Type test procedures (applicable to instrument transformers) 10.1 Dissolved gas and water content analysis
32	10.2 Mechanical test 10.3 Lightning impulse voltage test on the primary winding
33	10.4 Switching impulse voltage test on the primary winding—wet 10.5 External RIV test
34	10.6 Power frequency voltage withstand test—wet 10.7 Power frequency voltage withstand/partial discharge test—dry 10.8 Temperature rise test
36	10.9 Short-time mechanical and thermal rating test
39	11. Type test procedure (applicable to current transformers) 11.1 Secondary open-circuit voltage withstand test 12. Special test procedures 12.1 Endurance chopped-wave test
40	12.2 Internal arc test
41	12.3 Seismic qualification 13. Identification of test sample in the type test report 13.1 Document package related to transformer type
43	Annex A (normative) Test code
47	Annex B (informative) Dielectric test performed at an altitude of 1000 m or less for instrument transformers designed for installation at altitudes greater than 1000 m
48	Annex C (informative) Dielectric tests, oil sampling, and other related measurments in the field
49	Annex D (informative) Internal arc protection for instrument transformers
50	Annex E (normative) Validity of test reports and guidance for reviewing the design comparison report for the modified design
52	Annex F (normative) Rated voltage factor
53	Annex G (informative) Bibliography

Additional information

Standard Title	IEEE Standard of Performance and Test Requirements of Instrument Transformers of a Nominal Voltage of 115 kV and Above
Published Code	IEEE
Publication Date	2003
Pages Count	53

Preview PDF


PDF Format	Searchable	Printable	Preview Now

IEEE C57.13.5-2003

PDF Catalog

Related products