Shopping Cart

No products in the cart.

IEEE N42.31 2003

$42.25

American National Standard for Measurement Procedures for Resolution and Efficiency of Wide-Bandgap Semiconductor Detectors of Ionizing Radiation

Published By Publication Date Number of Pages
IEEE 2003 41
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Active. Standard measurement and test procedures are established for wide-bandgap semiconductor detectors such as cadmium telluride (CdTe), cadmium-zinc-telluride (CdZnTe), and mercuric iodide (HgI2) that can be used at room temperature for the detection and quantitative characterization of gamma-rays, X-rays, and charged particles. Standard terminology and descriptions of the principal features of the detectors are included. Included in this standard is an annex on interfering electromagnetic noise, which is a factor in such measurements.

PDF Catalog

PDF Pages PDF Title
2 Title Page
5 Introduction
Participants
7 Contents
9 1. Overview
1.1 Scope
1.2 Purpose
1.3 Abbreviations
10 2. References
3. Definitions, symbols, and abbreviations
3.1 Definitions
16 3.2 Symbols
17 3.3 Abbreviations
18 4. Introduction
19 5. Detector characteristics
20 5.1 Low-side tailing
21 5.2 Charge collection
22 5.3 Resolution and efficiency indicators
5.4 High-side area (HSA)
23 5.5 Peak-to-valley ratio
6. Specifications
6.1 Geometry and packaging
6.2 Detector capacitance
6.3 Detector bias
6.4 Leakage current
24 6.5 Temperature operating range and temperature sensitivity
6.6 Detector performance
6.7 Test sources
26 6.8 Source types
27 6.9 Source documentation
6.10 Timing properties
7. Spectrometer setup
7.1 Instrument grouping
28 7.2 Detector and preamplifier
7.3 Shaping amplifier (main amplifier)
29 7.4 Pulse generator (pulser)
7.5 ADC and multichannel analyzer (MCA)
8. Zero settings and calibration
8.1 Zero offset, pulse generator
30 8.2 Zero offset, amplifier
8.3 Zero offset, ADC
31 9. Measurements
9.1 Detector leakage current
32 9.2 Capacitance measurement
33 10. Measurement of energy resolution
34 10.1 Noise line width
35 11. Efficiency measurements
11.1 Gamma-ray counting efficiency for a full-energy peak
12. Peak-to-valley ratio
36 Annex A
37 Annex B
40 Annex C
IEEE N42.31 2003
$42.25