Shopping Cart

No products in the cart.

IEEE PC63.10a:2024 Edition

$30.33

American National Standard for Procedures for Compliance Testing of Unlicensed Wireless Devices Amendment 1

Published By Publication Date Number of Pages
IEEE 2024 23
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Amendment Standard – Active – Draft. The procedures for testing the compliance of a wide variety of unlicensed wireless transmitters (also called intentional radiators and license-exempt transmitters) including, but not limited to, remote control and security unlicensed wireless devices, frequency hopping and direct sequence spread spectrum devices, antipilferage devices, cordless telephones, medical unlicensed wireless devices, Unlicensed National Information Infrastructure (U-NII) devices, intrusion detectors, unlicensed wireless devices operating on frequencies below 30 MHz, automatic vehicle identification systems, and other unlicensed wireless devices authorized by a radio regulatory authority are covered in this standard. Excluded by this standard are test procedures for unlicensed wireless devices already covered in other published standards (e.g., Unlicensed Personal Communication Services (UPCS) devices).

PDF Catalog

PDF Pages PDF Title
1 ANSI/USEMCSC C63.10a-2024 Front Cover
2 Title page
4 Important Notices and Disclaimers Concerning USEMCSC StandardsDocuments
8 Participants
10 Introduction
11 Contents
12 1. Overview
1.1 Scope
13 1.5 Dimensional tolerances
14 6. Standard test methods
6.8 Frequency stability tests
6.8.1 Frequency stability with respect to ambient temperature
15 6.9 Occupied bandwidth tests
6.9.1 General requirements
6.9.2 Occupied bandwidth-relative measurement procedure
16 6.9.3 Occupied bandwidth-power bandwidth (99%) measurement procedure
17 7. Additional tests and requirements for specific devices
7.8 Evaluation of frequency-hopping device parameters
7.8.2 Carrier frequency separation
18 7.8.3 Number of hopping frequencies
9. Procedures for testing millimeter-wave systems
9.2 Equations
9.2.1 Equations to calculate and extrapolate field strength
19 9.7 Maximizing procedure for measurements
20 10. Procedures for measuring ultra-wideband devices
10.2 Radiated measurement procedure below 960 MHz
10.2.2 In situ compliance measurements for UWB ground-penetrating radar and wallimagingradar
21 12. Testing of Unlicensed National Information Infrastructure (U-NII) devices
12.4 Maximum conducted output power
12.4.1 General considerations
12.9 Undesirable/Unwanted emission measurement procedures
12.9.1 Average measurement procedures in the 5925 MHz to 7125 MHz band
22 12.9.2 Measurement procedures for devices operating in the 5850 MHz to 5895 MHz band
12.9.2.1 6 dB bandwidth
12.9.2.2 Out-of-band emissions
23 Back Cover
IEEE PC63.10a
$30.33