ISO 799:2004
$27.95
Ships and marine technology — Pilot ladders
| Published By | Publication Date | Number of Pages |
| ISO | 2004-02 | 18 |
ISO 799:2004 specifies requirements for a ship's pilot ladder which is provided to enable a maritime pilot to embark and disembark a ship safely along a vertical portion of the ship's hull. It is applicable to merchant ships which embark and disembark maritime pilots with the ship underway. National maritime safety administrations are urged to accept ladders complying with ISO 799:2004 on their ships, as complying fully with the requirements of the 1974 International Convention for the Safety of Life at Sea (SOLAS), as amended.
Related products
-
BS ISO 779:2005 2006
Paper, board and pulp. Determination of acid-soluble iron Published By Publication Date Number of Pages…
-
BS EN ISO 7199:2014
Cardiovascular implants and artificial organs. Blood-gas exchangers (oxygenators) Published By Publication Date Number of Pages…
-
ISO 7919-5:2005
Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 5:…
-
BS ISO 7992:2007
Iron ores for blast furnace feedstocks. Determination of reduction under load Published By Publication Date…
-
BS ISO 199:2014
Rolling bearings. Thrust bearings. Geometrical product specification (GPS) and tolerance values Published By Publication Date…
-
BS ISO 7299-1:2024
Diesel engines. End-mounting flanges for pumps – Fuel injection pumps Published By Publication Date Number…
-
BS ISO 7919-5:2005
Mechanical vibration. Evaluation of machine vibration by measurements on rotating shafts – Machine sets in…
-
ISO/OECD 789-10:2006
Agricultural tractors — Test procedures — Part 10: Hydraulic power at tractor/implement interface Published By…
-
ISO 7199:2009/Amd 1:2012
Cardiovascular implants and artificial organs — Blood-gas exchangers (oxygenators) — Amendment 1: Clarifications for test…
-
ISO 199:2005
Rolling bearings — Thrust bearings — Tolerances Published By Publication Date Number of Pages ISO…
-
BS ISO 789-12:2000:2019 Edition
Agricultural tractors. Test procedures – Low temperature starting Published By Publication Date Number of Pages…
-
ISO 7199:2009
Cardiovascular implants and artificial organs — Blood-gas exchangers (oxygenators) Published By Publication Date Number of…
-
ISO 899-2:2003
Plastics — Determination of creep behaviour — Part 2: Flexural creep by three-point loading Published…
-
ISO 7995:2002
Aéronautique et espace — Écrous hexagonaux à freinage interne, à filetage MJ, classifications: 1100 MPa…
-
BS ISO 7989-2:2007
Steel wire and wire products. Non-ferrous metallic coatings on steel wire – Zinc or zinc-alloy…
-
BS ISO 799:2004
Ships and marine technology. Pilot ladders Published By Publication Date Number of Pages BSI 2004…
-
ISO 7998:2005
Ophthalmic optics — Spectacle frames — Lists of equivalent terms and vocabulary Published By Publication…
-
ISO 7299-1:2007
Diesel engines — End-mounting flanges for pumps — Part 1: Fuel injection pumps Published By…
-
BS ISO 7919-2:2009
Mechanical vibration. Evaluation of machine vibration by measurements on rotating shafts – Land-based steam turbines…
-
ISO 7919-3:2009
Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 3:…
-
ISO 709:2001
Essential oils — Determination of ester value Published By Publication Date Number of Pages ISO…
-
BS ISO 709:2001:2005 Edition
Essential oils. Determination of ester value Published By Publication Date Number of Pages BSI 2005…
-
ISO 7299-2:2009
Diesel engines — End-mounting flanges for pumps — Part 2: High-pressure supply pumps for common…
-
ISO 7919-2:2009
Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 2:…
-
BS ISO 7989-1:2006
Steel wire and wire products. Non-ferrous metallic coatings on steel wire – General principles Published…
-
ISO 8799:2009
Surface active agents — Sulfated ethoxylated alcohols and alkylphenols — Determination of content of unsulfated…
-
BS ISO 199:2005:2006 Edition
Rolling bearings. Thrust bearings. Tolerances Published By Publication Date Number of Pages BSI 2006 18
-
ISO 7899-2:2000
Qualité de l’eau — Recherche et d’dénombrement des entérocoques intestinaux — Partie 2: Méthode par…
-
ISO 199:2014
Rolling bearings — Thrust bearings — Geometrical product specification (GPS) and tolerance values Published By…
-
ISO 899-1:2003
Plastics — Determination of creep behaviour — Part 1: Tensile creep Published By Publication Date…
-
BS EN ISO 7899-2:2000
Water quality. Detection and enumeration of intestinal enterococci in surface and waste water – Membrane…
-
ISO 7919-4:2009
Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 4:…
-
ISO 7989-2:2007
Steel wire and wire products — Non-ferrous metallic coatings on steel wire — Part 2:…
-
BS EN ISO 7799:2000
Metallic materials. Sheet and strip 3 mm thick or less. Reverse bend test Published By…
-
ISO 7992:2007
Iron ores for blast furnace feedstocks — Determination of reduction under load Published By Publication…
-
BS ISO 779:2001
Paper, board and pulp. Determination of iron Published By Publication Date Number of Pages BSI…
-
ISO 7989-1:2006
Fils et produits tréfilés en acier — Revêtements métalliques non ferreux sur fils d’acier —…
-
BS ISO 7919-2:2001:2002 Edition
Mechanical vibration of non-reciprocating machines. Measurements on rotating shafts and evaluation criteria – Land-based steam…
-
ISO 789-12:2000
Tracteurs agricoles — Méthodes d’essai — Partie 12: Démarrage à basse température Published By Publication…
-
BS EN ISO 8799:2009
Surface active agents. Sulfated ethoxylated alcohols and alkylphenols. Determination of content of unsulfated matter Published…
