NOTE 1 The dimensions of intermediate type and large type pressure caps and filler necks, which are not included in ISO 9817 : 1991, are specified in Annex JA.

NOTE 2 The dimensions of small type flattened pressure caps and filler necks, which are not included in ISO 9817 : 1991, are specified in Annex JB.

NOTE 3 This Standard specifies the characteristics of pressure caps, but since its characteristics requirements are only for showing the recommended design values, it is not intended, by itself, to be used for assessing the conformity of pressure caps.

NOTE 4 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.

ISO 9817 : 1991 Passenger cars – Engine cooling systems – Dimensions of pressure caps and their ramp seats on filler necks (MOD)

The symbols which denote the degree of correspondence in the contents between JIS and the corresponding International Standard are IDT (identical), MOD (modified) and NEQ (not equivalent) according to ISO/IEC Guide 21.

NOTE 1 The performance test method for small type flattened pressure caps, which is not included in ISO 9818 : 1991, is specified in Annex JA.

NOTE 2 The specification of the filler necks for small type flattened pressure cap performance test, which is not included in ISO 9818 : 1991, is given in Annex JB.

NOTE 3 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.

ISO 9818 : 1991 Passenger cars – Engine cooling systems – Test methods and marking ofpressure caps (MOD)

The symbols which denote the degree of correspondence in the contents between JIS and the corresponding International Standard are IDT (identical), MOD (modified) and NEQ (not equivalent) according to ISO/IEC Guide 21.