This document specifies test procedures for the acquisition and presentation of multipoint data on the following mechanical properties of plastics:<\/p>\n
dynamic modulus;<\/p>\n<\/li>\n
tensile properties at constant test speed;<\/p>\n<\/li>\n
ultimate stress and strain;<\/p>\n<\/li>\n
tensile stress-strain curves;<\/p>\n<\/li>\n
tensile creep;<\/p>\n<\/li>\n
Charpy impact strength;<\/p>\n<\/li>\n
puncture impact behaviour.<\/p>\n<\/li>\n<\/ul>\n
The test methods and test conditions apply predominantly to those plastics that can be injection- or compression-moulded or prepared as sheets of specified thickness from which specimens of the appropriate size can be machined.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 28<\/td>\n | National foreword <\/td>\n<\/tr>\n | ||||||
| 30<\/td>\n | European foreword <\/td>\n<\/tr>\n | ||||||
| 32<\/td>\n | Foreword <\/td>\n<\/tr>\n | ||||||
| 33<\/td>\n | Introduction <\/td>\n<\/tr>\n | ||||||
| 35<\/td>\n | 1 Scope 2 Normative references <\/td>\n<\/tr>\n | ||||||
| 36<\/td>\n | 3 Terms and definitions 4 Specimen preparation <\/td>\n<\/tr>\n | ||||||
| 37<\/td>\n | 5 Conditioning <\/td>\n<\/tr>\n | ||||||
| 38<\/td>\n | 6 Test requirements 6.1 General 6.2 Dynamic modulus 6.3 Tensile properties at constant test speed 6.3.1 General <\/td>\n<\/tr>\n | ||||||
| 39<\/td>\n | 6.3.2 Ultimate stress and strain 6.3.3 Tensile stress-strain curves 6.4 Tensile creep 6.5 Charpy impact strength <\/td>\n<\/tr>\n | ||||||
| 40<\/td>\n | 6.6 Puncture impact behaviour 7 Presentation of data <\/td>\n<\/tr>\n | ||||||
| 42<\/td>\n | 8 Precision <\/td>\n<\/tr>\n | ||||||
| 46<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Tracked Changes. Plastics. Acquisition and presentation of comparable multipoint data – Mechanical properties<\/b><\/p>\n |