1.1 This test method covers a procedure to determine the resistance of a section of the exterior insulation and finish system (EIFS) to outward loads imposed on an existing exterior wall assembly that has been in place on the building for an unspecified period of time. It is destructive in nature within the localized areas tested and requires appropriate repair of the EIFS cladding and sheathing once the test procedure has been completed. This test procedure utilizes mechanical methods to obtain information, which may be helpful in evaluating the natural application of negative wind loads on the EIFS assembly. Some variability of results should be anticipated within the wall assembly tested due to differences in installation procedures, exposure, or abuse subsequent to application.<\/p>\n
1.2 This test method is suitable for use on cladding assemblies that have been in place a short time (new construction), as well as for longer periods in order to evaluate detrimental effects on the EIFS lamina, insulation attachment, substrate integrity, and attachments after exposure to weather and other environmental conditions. It is not intended to evaluate the performance of structural framing. Test results on any particular building may be highly variable depending on specimen location and condition, and are subject to interpretation by the test specifier.<\/p>\n
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.<\/p>\n
This standard may involve hazardous materials, operations, or equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.<\/p>\n
Note 1 <\/p>\n
Due to variations in exposure and construction assemblies, field specimens selected for testing utilizing this test method may experience sudden failure and release of the imposed loads. See Note 7 for further information.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 1<\/td>\n | Scope Referenced Documents Terminology Significance and Use <\/td>\n<\/tr>\n | ||||||
| 2<\/td>\n | Apparatus Test Specimen <\/td>\n<\/tr>\n | ||||||
| 3<\/td>\n | FIG. 1 <\/td>\n<\/tr>\n | ||||||
| 4<\/td>\n | Procedure FIG. 2 FIG. 3 FIG. 4 FIG. 5 <\/td>\n<\/tr>\n | ||||||
| 5<\/td>\n | Calculations and Interpretation of Results FIG. 6 <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | Test Report Precision and Bias Keywords X1. Application of Test Loads: X1.1 X1.2 X1.3 X1.4 <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | X2. Calculation of Tributary Area (Examples): X2.1 Example One X2.2 Example Two X2.3 Example Three X2.4 Example Four X3. Equipment Diagrams: X3.1 X3.2 X3.3 X3.4 X3.5 X3.6 <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" E2359-06 Standard Test Method for Field Pull Testing of an In-Place Exterior Insulation and Finish System Clad Wall Assembly<\/b><\/p>\n |