ASTM-B754 2010

$40.63

B754-10 Standard Test Method for Measuring and Recording the Deviations from Flatness in Copper and Copper Alloy Strip

Published By	Publication Date	Number of Pages
ASTM	2010	5

Guaranteed Safe Checkout

Categories: 77.150.30 - Copper products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method describes a procedure for the measurement of distortions in thin metal strip and the application of these measurements to an equation that will indicate the deviation from flatness.

1.2 The distortions to be measured in this test method are dish, wavy edges, buckle, longitudinal corrugation, and herringbone.

1.3 This test method is not intended to include the measurement of coil set or longitudinal curl, camber or edgewise curvature, or twist.

1.4 This test method is limited to metal strip 0.003 to 0.020 in. (0.08 to 0.50 mm) thick and not more than 6.0 in. (150.0 mm) wide.

1.5 Units The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 The following safety hazard caveat pertains only to the test method(s) described in this test method. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use Apparatus
2	Test Specimens Procedure Calculation or Interpretation of Results Report Precision and Bias Keywords FIG. 1
3	FIG. 2 FIG. 3 FIG. 4
4	FIG. 5 FIG. 6
5	FIG. 7

Additional information

Standard Title	B754-10 Standard Test Method for Measuring and Recording the Deviations from Flatness in Copper and Copper Alloy Strip
Published Code	ASTM
Publication Date	2010
Pages Count	5
ICS Codes	77.150.30 - Copper products

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-B754 2010

PDF Catalog

Related products