šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-D178:2005 Edition

ASTM-D178:2005 Edition

$40.63

D178-01(2005) Standard Specification for Rubber Insulating Matting

Published By Publication Date Number of Pages
ASTM 2005 9
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This specification covers acceptance testing of rubber insulating matting for use as a floor covering for protection of workers.

1.2 Two types of matting, differing in chemical and physical characteristics, are provided and are designated as Type I and Type II matting.

The following safety hazards caveat applies only to the test method portion, Sections to , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1

Rubber insulating matting should remain flexible for use through normal temperature ranges.

Note 2

Rubber as used in this specification is a generic term that includes elastomers and elastomer compounds, regardless of origin.

1.3 This test method covers a small-scale horizontal laboratory screening procedure for measuring the rate, extent, or time, or a combination thereof, of burning of rigid or flexible cellular plastics in accordance with this test procedure.

1.4 Materials that exhibit pronounced shrinking, curling, or melting away upon heating cannot be evaluated by this test method.

1.5 This test method is not applicable to materials that cannot be ignited under the conditions of this test, or to materials that exhibit progressive combustion without flame (continued glowing or charring).

Note 3

The rate of burning or extent of burning of rigid cellular plastics also may be determined by Test Method D 3014 where the specimen is supported vertically.

1.5.1 Warning- During the course of combustion, gases or vapors, are evolved that may be hazardous to personnel. Adequate precautions should be taken to protect the operator.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Significance and Use
Classification
Ordering Information
Manufacture and Marking
Dimensions and Permissible Variations
Workmanship and Finish
Chemical and Physical Requirements
TABLE 1
3 Electrical Requirements
Guarantee
Sampling
Rejection
TABLE 2
TABLE 3
TABLE 4
4 Packaging
Thickness Measurements
Sequence of Testing
Electrical Tests
5 Chemical and Physical Tests
6 Precision and Bias
X1. TEST METHOD FOR RATE, EXTENT, OR TIME, OR A COMBINATION THEREOF, OF BURNING OF CELLULAR PLASTICS USING A SPECIMEN SUPPORTED BY A HORIZONTAL SCREEN
X1.1 Scope
X1.2 Referenced Documents
X1.3 Significance and Use
X1.4 Apparatus
7 X1.5 Test Specimen
X1.6 Conditioning
X1.7 Procedure
FIG. X1.1
FIG. X1.2
8 X1.8 Calculation
FIG. X1.3
9 X1.9 Report
X1.10 Precision and Bias

Related products

ASTM-D178
$40.63