ASTM-D7718:2011 Edition

$40.63

D7718-11 Standard Practice for Obtaining In-Service Samples of Lubricating Grease

Published By	Publication Date	Number of Pages
ASTM	2011	7

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This practice covers the method to obtain a trendable in-service lubricating grease sample from the following configurations including motor-operated valves, gearboxes, pillow-block bearings, electric motors, exposed bearings, open gears, or failed grease-lubricated components.

1.2 In some cases, it may be necessary to take more than one sample from a piece of equipment to obtain more trendable results. Examples of this could be a large bearing that does not fully rotate, such as a slew bearing, or one in which sufficient mixing does not otherwise occur.

1.3 Samples taken in the above manner may need to be mixed to form a more homogeneous sample. This may also be true of other samples such as those taken from open face bearings.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. The exception to this is a standard English units thread for which there is no metric equivalent.

Note 1The standard pipe thread referred to is the national pipe thread tapered thread.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Significance and Use Apparatus Hazards General Sampling Procedures, Limitations, and Considerations
3	Procedure for Active Sampling of a Grease-Lubricated Component FIG. 1
4	Procedure for Passive Sampling FIG. 2
5	Procedure for Active Sampling of Pillow-Block Bearings, Exposed Bearings, and Open Gears FIG. 3
6	Procedure for Sampling from Failed Grease-Lubricated Components Keywords