ASTM-F2623 2007
$40.63
F2623-07 Standard Specification for Polyethylene of Raised Temperature (PE-RT) SDR 9 Tubing
| Published By | Publication Date | Number of Pages |
| ASTM | 2007 | 6 |
ASTM F2623-07
Historical Standard: Standard Specification for Polyethylene of Raised Temperature (PE-RT) SDR 9 Tubing
ASTM F2623
Scope
1.1 This specification establishes requirements for polyethylene of raised temperature (PE-RT) SDR 9 tubing that is outside diameter controlled, and pressure rated for water at 73°F (23°C), 140°F (60°C) and 180°F (82.2°C). Included are requirements for material, workmanship, dimensions and tolerances, product tests, and markings for PE-RT tubing.
1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The tubing produced under this specification shall be permitted for use in general fluid transport, including hydronics and irrigations systems.
The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
hydronic heating; hydrostatic stress; irrigation; PE-RT; pipe; plastic pipe; polyethylene of raised temperature; PPI; pressure; radiant heating; tubing
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F2623-07
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Tubing Classification Materials Requirements TABLE 1 |
| 3 | Test Methods Retest and Rejection Marking TABLE 2 |
| 4 | Quality Assurance Keywords TABLE 3 TABLE 4 TABLE 5 TABLE 6 |
| 5 | X1. SOURCE OF HYDROSTATIC DESIGN BASIS X1.1 X1.2 X1.3 X1.4 X1.5 Stabilizer Verification |
| 6 | X2. UV LABELING GUIDELINES FOR PE-RT TUBING X2.1 X2.2 X2.3 X2.4 Caution Label X3. BENDING GUIDELINES FOR PE-RT TUBING X3.1 Cold Bending of Tubing |
