BS EN 60384-9:2005 2010
$142.49
Fixed capacitors for use in electronic equipment – Sectional specification: fixed capacitors of ceramic dielectric, Class 2
| Published By | Publication Date | Number of Pages |
| BSI | 2010 | 32 |
This part of IEC 60384 is applicable to fixed capacitors of ceramic dielectric with a defined temperature coefficient (dielectric Class 2), intended for use in electronic equipment, including leadless capacitors but excluding fixed surface mount multilayer capacitors of ceramic dielectric.1
Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | General Scope Object Normative references Information to be given in a detail specification |
| 7 | Outline drawing and dimensions Mounting Ratings and characteristics Rated capacitance range Particular characteristics Soldering Marking |
| 8 | Terms and definitions Marking The information given in the marking is normally selected fr |
| 9 | Preferred ratings and characteristics Preferred characteristics Preferred climatic categories Preferred values of ratings Rated temperature Rated voltage (UR) Category voltage (UC) Preferred values of rated capacitance and associated toleran Preferred values of rated capacitance Preferred tolerances on rated capacitance |
| 10 | Temperature characteristic of capacitance Quality assessment procedures Primary stage of manufacture Structurally similar components Certified records of released lots |
| 11 | Qualification approval Qualification approval on the basis of the fixed sample size Tests |
| 16 | Quality conformance inspection Formation of inspection lots |
| 17 | Test schedule Delayed delivery Assessment levels |
| 18 | Test and measurement procedures Special preconditioning Visual examination and check of dimensions Electrical tests Capacitance |
| 19 | Measuring conditions Requirements Tangent of loss angle (tan δ) Measuring conditions Accuracy Requirements Insulation resistance (Ri) Measuring conditions |
| 20 | Requirements Voltage proof Test conditions The voltages in Table 9 shall be applied between the measuri Requirement Temperature characteristic of capacitance Special preconditioning |
| 21 | Measuring conditions Requirements Robustness of terminations Resistance to soldering heat Special preconditioning Initial measurement Recovery: 24 h ± 2h. |
| 22 | Final inspection, measurements and requirements Solderability Conditions:. The performance requirements are given in Table 4. Rapid change of temperature Special preconditioning Initial measurement Number of cycles: 5 Recovery: 24 h ± 2 h. Vibration The following degree of severity of test Fc apply: |
| 23 | Final inspection, measurements and requirements Bump Initial measurements The detail specification shall state which of the following Final inspection, measurements and requirements Shock Initial measurements The detail specification shall state which of the preferred |
| 24 | Final inspection, measurements and requirements Climatic sequence Special preconditioning Initial measurements Dry heat Damp heat, cyclic, Test Db, first cycle Cold Final inspection and requirements |
| 25 | Low air pressure The test, if required in the detail specification, shall be Immediately after achieving the low pressure, UR shall be ap Final inspection and requirements Damp heat, cyclic, Test Db, remaining cycles Conditions of test Recovery: 24 h ± 2 h Final inspection, measurements and requirements |
| 26 | Damp heat, steady state Special preconditioning Initial measurement Conditions of test Recovery: 24 h ± 2 h Final inspection, measurements and requirements Endurance Special preconditioning Initial measurement |
| 27 | Conditions of test Recovery: 24 h ± 2 h. Final inspection, measurements and requirements Component solvent resistance (if applicable) Solvent resistance of the marking (if applicable) |
