BS EN 62675:2014
$102.76
Secondary cells and batteries containing alkaline or other non-acid electrolytes. Sealed nickel-metal hydride prismatic rechargeable single cells
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 22 |
IEC 62675:2014 specifies marking, designation, dimensions, tests and requirements for sealed nickel-metal hydride prismatic secondary single cells.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword Endorsement notice |
| 5 | Annex ZA (normative) Normative references to international publications with their corresponding European publications |
| 6 | English CONTENTS |
| 8 | 1 Scope 2 Normative references 3 Terms and definitions |
| 9 | 4 Parameter measurement tolerances 5 Designation and marking 5.1 Cell designation |
| 10 | 5.2 Cell termination 5.3 Marking 5.4 Safety recommendations 6 Dimensions Figures Figure 1 – Example of a sealed prismatic cell in steel container with two terminals and four lugs |
| 11 | Figure 2 – Example of a sealed prismatic cell in plastic container with two terminals Tables Table 1 – Dimensions for sealed nickel-metal hydride prismatic cells in steel containers Table 2 – Dimensions for sealed nickel-metal hydride prismatic cells in plastic containers |
| 12 | 7 Electrical tests 7.1 General 7.2 Charging procedure for test purposes 7.3 Discharge performance 7.3.1 General 7.3.2 Discharge performance at 20 °C Table 3 – Measurement tolerances in millimetres (valid for widths and lengths) |
| 13 | 7.3.3 Discharge performance at +5 °C 7.3.4 Discharge performance at –18 °C Table 4 – Discharge performance at 20 °C Table 5 – Discharge performance at +5 °C |
| 14 | 7.3.5 High rate current test 7.4 Charge retention Table 6 – Discharge performance at –18 °C Table 7 – High currents values |
| 15 | 7.5 Endurance 7.5.1 Endurance in cycles 7.5.2 Permanent charge endurance Table 8 – Endurance in cycles |
| 16 | 7.6 Charge acceptance at constant voltage 7.7 Overcharge 7.8 Vent plug operation 7.9 Safety device operation |
| 17 | 7.10 Gas leakage test 7.11 Storage 8 Mechanical tests 9 Physical appearance 10 Conditions for approval and acceptance 10.1 Type approval |
| 18 | 10.2 Batch acceptance Table 9 – Sequence of tests for type approval Table 10 – Recommended test sequence for batch acceptance |
| 19 | Bibliography |
