{"id":396845,"date":"2024-10-20T04:26:54","date_gmt":"2024-10-20T04:26:54","guid":{"rendered":"https:\/\/pdfstandards.shop\/product\/uncategorized\/ieee-c63-19-2006-2\/"},"modified":"2024-10-26T08:14:22","modified_gmt":"2024-10-26T08:14:22","slug":"ieee-c63-19-2006-2","status":"publish","type":"product","link":"https:\/\/pdfstandards.shop\/product\/publishers\/ieee\/ieee-c63-19-2006-2\/","title":{"rendered":"IEEE C63.19-2006"},"content":{"rendered":"
New IEEE Standard – Superseded. Revised by ANSI C63.19-2007. Uniform methods of measurement for compatibility between hearing aids and wireless communications devices are set forth.<\/p>\n
PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
---|---|---|---|---|---|---|---|
1<\/td>\n | ANSI C63.19-2006 Front Cover <\/td>\n<\/tr>\n | ||||||
3<\/td>\n | Title Page <\/td>\n<\/tr>\n | ||||||
4<\/td>\n | Acknowledgments <\/td>\n<\/tr>\n | ||||||
6<\/td>\n | Introduction Participants <\/td>\n<\/tr>\n | ||||||
11<\/td>\n | American National Standard Methods of Measurement of Compatibility between Wireless Communications Devices and Hearing Aids 1. Overview 1.1 Scope 1.2 Purpose <\/td>\n<\/tr>\n | ||||||
13<\/td>\n | 1.3 Organization and use of the document <\/td>\n<\/tr>\n | ||||||
15<\/td>\n | 2. Normative references <\/td>\n<\/tr>\n | ||||||
18<\/td>\n | 3. Definitions, acronyms, and abbreviations 3.1 Definitions <\/td>\n<\/tr>\n | ||||||
21<\/td>\n | 3.2 Acronyms and abbreviations <\/td>\n<\/tr>\n | ||||||
22<\/td>\n | 4. Wireless device, RF emissions test <\/td>\n<\/tr>\n | ||||||
23<\/td>\n | 4.1 Measured RF interference level <\/td>\n<\/tr>\n | ||||||
24<\/td>\n | 4.2 Test equipment and facilities <\/td>\n<\/tr>\n | ||||||
26<\/td>\n | 4.3 Test setup and validation <\/td>\n<\/tr>\n | ||||||
31<\/td>\n | 4.4 Near-field test procedure <\/td>\n<\/tr>\n | ||||||
39<\/td>\n | 5. Hearing aid RF near-field immunity test 5.1 Test facilities and equipment <\/td>\n<\/tr>\n | ||||||
40<\/td>\n | 5.2 Test setup and validation <\/td>\n<\/tr>\n | ||||||
42<\/td>\n | 5.3 RF immunity test procedure\u2014primary <\/td>\n<\/tr>\n | ||||||
48<\/td>\n | 5.4 RF immunity test procedure\u2014alternate <\/td>\n<\/tr>\n | ||||||
51<\/td>\n | 6. Wireless device T-Coil signal test 6.1 Test facilities and equipment <\/td>\n<\/tr>\n | ||||||
64<\/td>\n | 7.3 T-Coil coupling mode <\/td>\n<\/tr>\n | ||||||
66<\/td>\n | 7.4 Accessories and options <\/td>\n<\/tr>\n | ||||||
67<\/td>\n | 7.5 Product line compliance 8. Calibration and measurement uncertainty 8.1 General 8.2 Ambient conditions <\/td>\n<\/tr>\n | ||||||
68<\/td>\n | 8.3 Specific calibration requirements 8.4 Measurement uncertainty 9. Test report 9.1 Test plan 9.2 Applicable standards 9.3 Equipment unit tested <\/td>\n<\/tr>\n | ||||||
69<\/td>\n | 9.4 Test configuration 9.5 List of test equipment 9.6 Units of measurement 9.7 Location of test site 9.8 Measurement procedures 9.9 Reporting measurement data <\/td>\n<\/tr>\n | ||||||
70<\/td>\n | 9.10 General and special conditions 9.11 Summary of results 9.12 Required signatures 9.13 Test report annexes 9.14 Test report disposition <\/td>\n<\/tr>\n | ||||||
71<\/td>\n | Annex A (normative) Definition of reference axes <\/td>\n<\/tr>\n | ||||||
75<\/td>\n | Annex B (normative) Test frequencies <\/td>\n<\/tr>\n | ||||||
77<\/td>\n | Annex C (normative) Equipment and setup calibration <\/td>\n<\/tr>\n | ||||||
87<\/td>\n | Annex D (normative) Test equipment specifications <\/td>\n<\/tr>\n | ||||||
108<\/td>\n | Annex E (informative) Sample measurement uncertainty estimates <\/td>\n<\/tr>\n | ||||||
113<\/td>\n | Annex F (informative) Use of Helmholtz coils for calibration <\/td>\n<\/tr>\n | ||||||
121<\/td>\n | Annex G (informative) RF envelope comparison for US WD systems <\/td>\n<\/tr>\n | ||||||
126<\/td>\n | Annex H \n(informative) \nExplanation of rationale used in this standard <\/td>\n<\/tr>\n | ||||||
127<\/td>\n | Annex I (informative) Measurement of peak power across multiple airlink technologies <\/td>\n<\/tr>\n | ||||||
135<\/td>\n | Annex J \n(informative) \nSample HAC application forms <\/td>\n<\/tr>\n | ||||||
139<\/td>\n | Annex K \n(informative) \nBibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Method of Measurement for Hearing Aid Compatibility with Wireless Communications<\/b><\/p>\n |