Shopping Cart

No products in the cart.

ASTM-C1716:2010 Edition

$40.63

C1716/C1716M-10 Standard Specification for Compression Testing Machine Requirements for Concrete Masonry Units, Related Units, and Prisms

Published By Publication Date Number of Pages
ASTM 2010 8
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This specification provides minimum design standards for testing machines used to measure the compressive strength of concrete masonry units, related units, and masonry prisms covered under Test Methods C140 and C1314 .

1.2 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this standard.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Testing Machine Requirements
4 Keywords
A1. DETERMINING USABLE BEARING AND SUPPORT AREA OF PLATENS AND BLOCK
A1.1
A1.2
A1.3
5 FIG. A1.1
6 FIG. A1.2
7 X1. MAXIMUM ALLOWABLE MACHINERY CAPACITY BASED ON DIFFERENTIAL STRAIN
X1.1
X1.2
X1.3
X1.4
FIG. A1.3
8 X1.5
ASTM-C1716
$40.63