ASTM-D4167:2007 Edition

$40.63

D4167-97(2007) Standard Specification for Fiber-Reinforced Plastic Fans and Blowers

Published By	Publication Date	Number of Pages
ASTM	2007	5

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers centrifugal and axial fans and blowers with airstream components fabricated of fiber-reinforced thermoset plastics (FRP) for corrosion resistance. Internal structures may include encapsulated metal fastening devices, hubs, and shafts.

1.2 Reinforcing materials other than fibrous glass may be used in the fabrication, provided the fans and blowers produced meet all the requirements of this specification.

1.3 The term fans as used in this specification includes fans and blowers, both centrifugal and axial.

1.4 The purpose of this specification is to provide users, system designers, specifiers, and manufacturers of FRP fans with minimum standards for fan construction and a common basis for determining safe operating speeds.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

Note 1There is no similar or equivalent ISO standard.

Note 2Appendix X2 contains a list of documents that may be of interest to designers of fan systems.

1.6 This standard does not puport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and helath practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Construction of Fan Housings
2	Construction of Fan Wheels Spark-Resistant Construction Shaft-Hole Closures Balancing and Test Running
3	Fan Aerodynamic Rating and Testing Safe Operating Speed TABLE 1
4	Nameplates Keywords X1. NFPA REQUIREMENTS X1.1 X2. DOCUMENTS OF POSSIBLE INTEREST TO DESIGNERS OF FAN SYSTEMS X2.1 X3. GAS DENSITY AT FAN INLET X3.1
5	X4. RESIN SELECTION FOR CORROSION RESISTANCE X4.1